Pharmacokinetics of the low molecular weight heparin dalteparin in cats

Reinhard Mischke1, Judith Schmitt, Sonja Wolken

  • 1Small Animal Clinic, University of Veterinary Medicine Hannover, Bünteweg 9, D-30559 Hannover, Germany. Reinhard.Mischke@tiho-hannover.de

Low molecular weight heparin (LMWH) is used as an anticoagulant in cats although only limited pharmacokinetic data are available in this species. The aim of the present study was to establish the pharmacokinetics of dalteparin in cats based on anti-FXa heparin activities. Groups of clinically healthy cats (six animals per treatment) received individual LMWH injections at three different doses intravenously (IV) (25, 50, 100 anti-factor Xa international units [IU anti-FXa]/kg) or subcutaneously (SC) (50, 100, 200 IU anti-FXa/kg). Blood samples were collected before and at various times after injection. Anti-FXa activity was measured with a chromogenic substrate test. Following IV injection, maximum plasma heparin activities (C(max)) were 0.67 ± 0.14, 1.44 ± 0.22 and 2.87 ± 0.38 IU anti-FXa/mL, respectively. The calculated mean half-life (t(½)) was between 39 and 57 min and was not significantly dose-dependent (P=0.139). The volume of distribution (35-39 mL/kg) was almost equivalent to the plasma volume. After SC injection, C(max) values of 0.41 ± 0.10, 0.86 ± 0.17 or 1.91 ± 0.16 IU anti-FXa/mL, respectively, were calculated at 91-110 min post-injection. The t(½) values were between 106 and 122 min and were not significantly influenced by dose (P=0.784). The bioavailability after SC injection was approximately 100%. The high bioavailability of the SC administered LMWH dalteparin in cats was consistent with other species and indicated predictable blood levels. However, the comparatively short t(½) may indicate the necessity of multiple daily injections, which should be verified in clinical trials.

Related Concept Videos

Anticoagulant Drugs: Low-Molecular-Weight Heparins01:30

Anticoagulant Drugs: Low-Molecular-Weight Heparins

Hemostasis is a crucial process that prevents excessive blood loss from damaged blood vessels. It involves various mechanisms such as vasoconstriction, platelet adhesion and activation, and fibrin formation. The importance of each mechanism depends on the type of vessel injury. In contrast, thrombosis is the abnormal formation of a blood clot within the blood vessels, leading to potential complications if the clot obstructs blood flow. Thrombosis can be caused by increased coagulability of the...
Pharmacokinetic–Pharmacodynamic Relationship: Duration of Dose-Effect Relationship01:14

Pharmacokinetic–Pharmacodynamic Relationship: Duration of Dose-Effect Relationship

For drugs producing a quantal response, onset occurs when plasma concentration reaches a minimum effective level (Cmin). The drug's action duration depends on how long the plasma concentration remains above Cmin.Two primary factors influence this duration: dose size and the rate of drug removal from the action site. Both depend on the drug's redistribution to poorly perfused tissues and elimination processes. A larger dose promotes rapid onset and prolongs the effect's duration.Consider a...
Nonlinear Pharmacokinetics: Dependence of Elimination Half-Life and Dose Clearance01:23

Nonlinear Pharmacokinetics: Dependence of Elimination Half-Life and Dose Clearance

The elimination half-life and drug clearance of drugs following nonlinear kinetics can vary with dosage. The Michaelis-Menten parameters and drug concentration influence these factors. As the dose increases, the elimination half-life tends to lengthen, resulting in a reduction in clearance and a disproportionately larger area under the curve. The total clearance can be derived from the Michaelis-Menten equation for drugs following a one-compartment model.
A study on guinea pigs examined the...
Nonlinear Pharmacokinetics: Drug Elimination for IV Bolus Injection00:59

Nonlinear Pharmacokinetics: Drug Elimination for IV Bolus Injection

In pharmacokinetics, the elimination rate of a drug following a capacity-limited model is primarily controlled by two parameters: Vmax and KM. These parameters are crucial in how the drug behaves inside the body after administration.
Following the administration of a single intravenous (IV) bolus injection, we can determine the concentration of the drug in the plasma at any given time. This calculation is achieved using a specific equation that integrates the values of Vmax and KM.
We can also...
Dosage Regimens: Partial Pharmacokinetic Parameters01:01

Dosage Regimens: Partial Pharmacokinetic Parameters

It is not uncommon for complete drug pharmacokinetic profiles to remain elusive in pharmacokinetics. This necessitates certain educated assumptions by pharmacokineticists to determine appropriate dosage regimens without comprehensive pharmacokinetic data from animal or human studies. One prevalent assumption is setting the bioavailability factor, denoted as F, to 1 or 100%. This assumption caters to the scenario where a drug doesn't achieve full systemic absorption, resulting in the patient...
Effect of Hepatic Disease on Pharmacokinetics: Active Drug, Metabolite and Fraction of Metabolized Drug01:14

Effect of Hepatic Disease on Pharmacokinetics: Active Drug, Metabolite and Fraction of Metabolized Drug

In pharmacotherapy, monitoring drug concentrations is paramount, especially for drugs whose therapeutic effects hinge on both the active compound and its metabolite. Hepatic impairment profoundly influences drug potency by altering liver function. If the drug is more potent than its metabolite, impaired liver function amplifies drug activity due to elevated drug concentration levels. Conversely, if the metabolite holds greater potency, diminished liver function diminishes drug activity by...