Related Experiment Video
Updated: May 28, 2026

Comparative Analysis of Lower Limb Kinematics between the Initial and Terminal Phase of 5km Treadmill Running
Published on: July 17, 2020
Relationship between three-dimensional kinematics of knee and trunk motion during shuttle run cutting
Yasuharu Nagano1, Hirofumi Ida, Masami Akai
1Department of Health and Sports, Niigata University of Health and Welfare, Niigata, Japan. nagano@nuhw.ac.jp
Abstract:
Female athletes are considered to exhibit knee and trunk motion that is characteristic of anterior cruciate ligament (ACL) injury. The aim of this study was to examine the in vivo motion of the trunk and knee during a cutting manoeuvre and determine the relationship between them. All participants (10 male and 10 female college athletes) performed a shuttle run cutting task with the left limb. Trunk inclination (forward and lateral) and knee joint angles (flexion/extension, abduction/adduction, and internal/external tibial rotation) were calculated. Differences between the sexes and associations between knee motion and trunk inclination were examined. An increase in trunk forward inclination was strongly correlated with an increase in knee flexion angle and moderately correlated with a decrease in the excursion of internal tibial rotation. An increase in right trunk lateral inclination was moderately correlated with an increase in excursion of internal tibial rotation. The results also showed differences between the sexes in trunk forward inclination, lateral inclination, and knee flexion angle, but no such differences in knee abduction or internal tibial rotation. Trunk inclination is related to knee flexion and excursion of internal tibial rotation. Female athletes demonstrate a low trunk forward inclination and knee flexion angle, a posture that resembles that of ACL injury.
More Related Videos
Related Concept Videos
Relative Motion Analysis - Acceleration
Kinematic Equations - III
Using the kinematic equations,...
Relative Motion Analysis - Velocity
When an external force is exerted, it sets the crank into a rotational movement. This, in turn, instigates the motion of the connecting rod, leading to what is referred to as a general plane motion. This process involves two key points - point A on the connecting rod...
Space Trusses: Problem Solving
Consider a tripod consisting of a tetrahedral space truss with a ball-and-socket joint at C. Suppose the height and lengths of the horizontal and vertical...

