Automated Nanocosm test system to assess the effects of stressors on two interacting populations

Kaarina Foit1, Oliver Kaske, Dierk-Steffen Wahrendorf

  • 1UFZ--Helmholtz Centre for Environmental Research, Department of System Ecotoxicology, Permoserstrasse 15, D-04318 Leipzig, Germany. kaarina.foit@ufz.de

Related Concept Videos

Stress Concentrations01:13

Stress Concentrations

The concept of stress concentration is crucial for understanding how materials respond under bending stresses, particularly when there are irregularities or discontinuities in the material's geometry. Normally, stress in a symmetric member subjected to pure bending is assumed to be uniformly distributed across the entire cross-section. However, this assumption does not hold when there are variations in the cross-sectional geometry or the presence of notches and holes.
The stress concentration...
Stress Concentrations01:24

Stress Concentrations

Stress concentration is when stress intensifies near discontinuities such as holes or abrupt cross-sectional changes in a structural member. This localized stress can often surpass the average stress within the member. The stress distribution in flat bars, either with a circular hole or varying widths connected by fillets, can be determined experimentally using a photoelastic method. The results are based on ratios of geometric parameters like the ratio of the hole's radius to the smaller width...
Stress Response System01:21

Stress Response System

The stress response system, also known as the fight-or-flight response, is the body's automatic physiological reaction to perceived threats. Hans Selye introduced the concept of General Adaptation Syndrome (GAS) to describe the predictable pattern of changes that occur in response to stress. GAS consists of three sequential stages: alarm, resistance, and exhaustion. This model helps explain how chronic stress can contribute to health problems.
Alarm stage
In the alarm stage, the body's initial...
Applications of Stress01:04

Applications of Stress

Consider a structure made of a boom and a rod designed to support a load. These two components are connected by a pin and stabilized by brackets and pins. The boom and the rod are detached from their supports to assess the different stresses imposed on this structure, and a free-body diagram is drawn. Then, all the forces applied, including the load acting on the structure, are identified. The reaction forces exerted on both the boom and the rod are computed using the equilibrium equations.
The...