Related Experiment Video

Updated: May 27, 2026

Atomic Layer Deposition of Vanadium Dioxide and a Temperature-dependent Optical Model
11:10

Atomic Layer Deposition of Vanadium Dioxide and a Temperature-dependent Optical Model

Published on: May 23, 2018

Thermodynamic study of gaseous vanadium phosphates by high-temperature mass spectrometry

S M Shugurov1, S I Lopatin

  • 1Chemical Department, St. Petersburg State University, Universitetskii pr. 26, 198504, St. Petersburg, Russia. transformer2002@yandex.ru

Rapid Communications in Mass Spectrometry : RCM
|November 19, 2011
PubMed

More Related Videos

Analysis of Volatile and Oxidation Sensitive Compounds Using a Cold Inlet System and Electron Impact Mass Spectrometry05:48

Analysis of Volatile and Oxidation Sensitive Compounds Using a Cold Inlet System and Electron Impact Mass Spectrometry

Published on: September 5, 2014

Quantitative Analysis by Thermogravimetry-Mass Spectrum Analysis for Reactions with Evolved Gases06:51

Quantitative Analysis by Thermogravimetry-Mass Spectrum Analysis for Reactions with Evolved Gases

Published on: October 29, 2018

Related Concept Videos

The Van der Waals Equation01:26

The Van der Waals Equation

The ideal gas law is based on two simplifying assumptions: first, that there are no intermolecular attractions between gas molecules, and second, that the volume occupied by the molecules themselves is negligible compared with the volume of the container. However, these assumptions don't hold up under all conditions - specifically, at high pressures and low temperatures, as gas tends to deviate from ideal gas behavior.The van der Waals equation is an enhanced version of the ideal gas law,...
Van der Waals Equation01:10

Van der Waals Equation

The ideal gas law is an approximation that works well at high temperatures and low pressures. The van der Waals equation of state (named after the Dutch physicist Johannes van der Waals, 1837−1923) improves it by considering two factors.
First, the attractive forces between molecules, which are stronger at higher densities and reduce the pressure, are considered by adding to the pressure a term equal to the square of the molar density multiplied by a positive coefficient a. Second, the volume...
Volatilization01:10

Volatilization

Volatilization gravimetry is an analytical technique that measures the mass lost due to the volatilization of the substance. This technique is used to estimate the amount of volatile material in a sample. To perform this method, heat a known amount of the sample to a high temperature in a crucible or other suitable vessel. The volatile substance in the sample evaporates, and the vapor is completely expelled from the crucible either by heating the sample or bubbling a stream of inert gas through...
Phase Transitions: Melting and Freezing02:39

Phase Transitions: Melting and Freezing

Heating a crystalline solid increases the average energy of its atoms, molecules, or ions, and the solid gets hotter. At some point, the added energy becomes large enough to partially overcome the forces holding the molecules or ions of the solid in their fixed positions, and the solid begins the process of transitioning to the liquid state or melting. At this point, the temperature of the solid stops rising, despite the continual input of heat, and it remains constant until all of the solid is...
Variables and Equations of State01:27

Variables and Equations of State

The physical state of a pure substance can be defined by certain state variables such as volume (V), pressure (p), temperature (T), and amount of substance (n). When two gases are separated by a movable wall, the gas with the higher pressure naturally compresses the gas with the lower pressure. This causes the high-pressure gas to expand and the low-pressure gas to compress until both gases achieve mechanical equilibrium. At this point, their pressures equalize, and the movement of the wall...
pV-Diagrams01:18

pV-Diagrams

The pV diagram, which is a graph of pressure versus volume of the gas under study, is helpful in describing certain aspects of the substance. When the substance behaves like an ideal gas, the ideal gas equation describes the relationship between its pressure and volume. On a pV diagram, it is common to plot an isotherm, which is a curve showing p as a function of V with the number of molecules and the temperature fixed. Then, for an ideal gas, the product of the pressure of the gas and its...