Improving the mechanical properties of chitosan-based heart valve scaffolds using chitosan fibers

Chitosan is being widely studied for tissue engineering applications due to its biocompatibility and biodegradability. However, its use in load-bearing applications is limited due to low mechanical properties. In this study, we investigated the effectiveness of a chitosan fiber reinforcement approach to enhancing the mechanical properties of chitosan scaffolds. Chitosan fibers were fabricated using a solution extrusion and neutralization method and incorporated into porous chitosan scaffolds. The effects of fiber/scaffold mass ratio, fiber mechanical properties and fiber length on scaffold mechanical properties were studied. The results showed that incorporating fibers improved scaffold strength and stiffness in proportion to the fiber/scaffold mass ratio. A fiber-reinforced, heart valve scaffold achieved leaflet tensile strength values of 220±17 kPa, comparable to the radial values of human pulmonary valve leaflets. Additionally, the effects of 2 mm fibers were found to be up to threefold greater than 10 mm fibers at identical mass ratios. Heparin crosslinking of fibers produced a reduction in fiber strength, and thus failed to produce additional improvements to fiber-reinforced scaffold properties. Despite this reduction in fiber strength, heparin-modified fibers still improved the mechanical properties of reinforced scaffolds, but to a lesser extent than unmodified fibers. The results demonstrate that chitosan fiber reinforcement can be used to achieve porous chitosan scaffold strength approaching that of tissue, and that fiber length and mechanical properties are important parameters in defining the degree of mechanical improvement.