Related Experiment Video
Updated: May 27, 2026

Software-Assisted Quantitative Measurement of Osteoarthritic Subchondral Bone Thickness
Published on: March 18, 2022
A classification-system improves the intra- and interobserver reliability of radiographic diagnosis of
Ingmar Ipach1, Eva-Maria Arlt, Falk Mittag
1Department of Orthopaedic Surgery, University Hospital of Tübingen, Tübingen, Germany.
Abstract:
Early detection of pistol-grip-deformity may be beneficial in optimising the outcome and the cost effectiveness of surgery. It is important to identify reliable radiographic parameters in assessing femoro-acetabular impingement (FAI) to develop a treatment algorithm. Radiographs of 47 patients ranging from "pistol grip deformity" to a normal head-neck-junction were measured for alpha angle and head ratio, and then classified by two different observers. The Bland-Altman plot was used for inter- and intraobserver agreement of alpha angle and head ratio. Inter- and intraobserver agreement for classification of "pistol grip deformity" was determined using weighted Cohen's kappa coefficient. Observer I achieved a kappa coefficient of 0.97. Observer II achieved a kappa coefficient of 0.92. An interobserver kappa coefficient between 0.87 and 0.92 was achieved by using a classification system. By testing for interobserver agreement, a bias of -0.004 with an upper limit of 0.461 and a lower limit of -0.47 was seen for the ratio and a bias of -3.7 with an upper limit of 17.2 and a lower limit of -24.6 for the alpha angle. Therefore, poor results were seen for intra- and interobserver reliability by using only a single plane for classification of "pistol grip deformity". The strength of agreement could be improved by using a classification system (based on two planes).
Related Concept Videos
Structural Classification of Joints
A fibrous joint is where the adjacent bones are united by fibrous connective...
Classification of Bones
Long and Short Bones
The appendicular skeleton, particularly the upper and lower limbs, is primarily made of long and short bones. The long...
Functional Classification of Joints
The functional classification of joints is determined by the amount of mobility between the adjacent bones. Joints are functionally classified as a synarthrosis or immobile joint, an amphiarthrosis or slightly moveable joint, or as a diarthrosis, a freely moveable joint. Fibrous and cartilaginous joints can be functionally classified as either synarthroses or amphiarthroses, whereas all synovial joints are classified as diarthroses.
Synarthrosis
An immobile...
Classification of Systems-II
Classification of Systems-I
Homogeneity dictates that if an input x(t) is multiplied by a constant c, the output y(t) is multiplied by the same constant. Mathematically, this is expressed as:
