Forearm bone mineral density measurement with different scanning positions: a study in right-handed Chinese using...

The purpose of our study was to determine whether different scanning positions influence forearm bone mineral density (BMD) measurements and to evaluate the association between forearm BMDs in different scanning positions and those of other skeleton sites. The study population consisted of 30 right-handed healthy Chinese volunteers. BMD was measured with GE Lunar Prodigy at the left forearm in both sitting and supine positions, and at lumbar spine and the right femur. All subjects received repeated measurements in the same day (repositioning), and the average of repeated BMD results was used for analysis. The BMD precision errors of the nondominant forearm in the sitting and supine positions varied from 1.13% to 2.46%. There were no statistically significant differences between BMD precision errors for each region of interest (ROI) between sitting and supine positions (all the p values were greater than 0.05). When comparing BMDs on the same side in the sitting position with those in the supine position, there were significant differences at both the 1/3 radius level and in the total radius (p<0.05). The BMD values at these ROIs obtained in the supine position were lower than those in the routine sitting position. The BMDs of the ultradistal radius in the both 2 different scanning positions were significantly associated with lumbar spine and femoral neck BMD, respectively. The total radius BMD in the different positions was associated with the BMD of the femoral neck. A change in body scanning position from sitting to supine will significantly influence forearm BMD results.