Related Experiment Video

Updated: May 26, 2026

Isolation and Identification of Waterborne Antibiotic-Resistant Bacteria and Molecular Characterization of their Antibiotic Resistance Genes
08:58

Isolation and Identification of Waterborne Antibiotic-Resistant Bacteria and Molecular Characterization of their Antibiotic Resistance Genes

Published on: March 3, 2023

Statistical assessment of seafront and beach water quality of Mumbai, India

Ritesh Vijay1, Swapnil R Kamble, S S Dhage

  • 1National Environmental Engineering Research Institute, Nehru Marg, Nagpur 440020, India. r_vijay@neeri.res.in

Water Science and Technology : a Journal of the International Association on Water Pollution Research
|January 5, 2012
PubMed

More Related Videos

Façade-Level Monitoring of CO2 Variability under Urban Heat Island Conditions using Low-Cost Sensor Data Loggers07:12

Façade-Level Monitoring of CO2 Variability under Urban Heat Island Conditions using Low-Cost Sensor Data Loggers

Published on: December 12, 2025

Bioindication Testing of Stream Environment Suitability for Young Freshwater Pearl Mussels Using In Situ Exposure Methods07:53

Bioindication Testing of Stream Environment Suitability for Young Freshwater Pearl Mussels Using In Situ Exposure Methods

Published on: September 5, 2018

Related Concept Videos

Testing Water Quality01:14

Testing Water Quality

When the quality of water for concrete preparation is uncertain, its impact on the setting time of cement and compressive strength of mortar is assessed by comparison with de-ionized or distilled water benchmarks. American Society for Testing and Materials (ASTM) C1602 requires the setting times to be within 90 minutes of the control, British Standard (BS) 3146:1980 allows a 30-minute variance in the initial setting, while British Standards European Norm (BS EN) 1008 specifies initial setting...
Quality of Water01:19

Quality of Water

In concrete preparation, the quality of water is paramount as it affects the strength and durability of the concrete. Potable water is usually preferred; however, it must not have excessive sodium or potassium to prevent compromising the concrete's integrity. Water quality is typically evaluated based on impurities such as dissolved solids, chlorides, and sulfates, and its pH value is ideally between 6 and 8. Even slightly acidic natural water may be acceptable unless it contains harmful...
Effect of Sea Water on Concrete01:22

Effect of Sea Water on Concrete

Concrete exposed to seawater can undergo degradation like the dissolution of ettringite and gypsum, increasing the material's porosity and decreasing its strength. In contrast, the crystallization of salts within the concrete's pores can cause expansion, particularly above the waterline where evaporation occurs. Nonetheless, this expansion only happens when seawater, enabled by the concrete's permeability, manages to infiltrate the structure.
Concrete in areas between tide marks, which undergo...
Marine Microbial Ecology01:30

Marine Microbial Ecology

Marine microbial ecosystems are shaped by distinct physicochemical limits, including high salinity, low nutrient availability, and fluctuating oxygen levels. These conditions favor smaller microbial cell sizes, which maximize their surface-to-volume ratio for efficient nutrient uptake.Microbial activity and community composition are closely linked to biogeochemical cycles, particularly in dynamic environments like estuaries, where halotolerant microbes thrive in response to variable salinity...