Related Experiment Video
Updated: May 26, 2026

A Two-interval Forced-choice Task for Multisensory Comparisons
Published on: November 9, 2018
Spectral loudness summation of nonsimultaneous tone pulses
Wiebke Heeren1, Jan Rennies, Jesko L Verhey
1Department of Experimental Audiology, Otto-von-Guericke University, Leipziger Strasse 44, D-39120 Magdeburg, Germany.
Abstract:
The level of broadband signals is usually lower than that of equally loud narrow-band signals. This effect, referred to as spectral loudness summation, is commonly measured for broadband signals where all frequency components are presented simultaneously. The present study investigated to what extent spectral loudness summation also occurs for nonsimultaneously presented frequency components. Spectral loudness summation was measured in normal-hearing listeners with an adaptive forced-choice procedure for sequences of short tone pulses with varying frequencies, randomly chosen from a set of five frequencies. In addition, spectral loudness summation was measured for the simultaneous presentation of all five frequencies. The comparison stimulus consisted of tone pulses with the same frequency for all tone pulses of the sequence and the same repetition rate and overall duration as the test signal. The pulse duration was 10, 20, 50, or 100 ms and the inter-pulse interval ranged from 0 to 390 ms. In general, a considerable nonsimultaneous spectral loudness summation was found for short pulse durations and inter-pulse intervals, but a residual effect was also observed for the largest inter-pulse interval. The data are discussed in the light of repetition-rate dependent spectral loudness summation and effects of persistence of specific loudness after tone-pulse offset.
Related Concept Videos
Perceiving Loudness, Pitch, and Location
Place theory, or place coding, suggests that different pitches are heard because various sound waves activate specific locations along the cochlea's basilar membrane. The brain determines the pitch of a sound by identifying...
Bandpass Sampling
A bandpass signal has a spectrum with a lower frequency limit, denoted as ω1, and an upper frequency limit, denoted as ω2. The spectrum...
Beats
Aliasing
If the sampling frequency is below the Nyquist rate, these replicas overlap, preventing the original signal...
Perception of Sound Waves
The pitch of a sound depends on the frequency and the pressure amplitude of the source. Two sounds of the same frequency...
Graded Potential
Graded potentials fall into two categories: depolarizing and hyperpolarizing. Depolarizing graded potentials typically occur when sodium (Na+) or calcium...

