Stability and multiattractor dynamics of a toggle switch based on a two-stage model of stochastic gene expression

Michael Strasser1, Fabian J Theis, Carsten Marr

  • 1Institute for Bioinformatics and Systems Biology, Helmholtz Zentrum München, German Research Center for Environmental Health, Neuherberg, Germany.

Biophysical Journal
|January 10, 2012
PubMed

Related Concept Videos

Switching of BJT01:22

Switching of BJT

Switching behavior in Bipolar Junction Transistors (BJTs) is a fundamental aspect utilized in various electronic circuits, particularly for digital logic applications like switches and amplifiers. In a typical switching circuit, a BJT alternates between cut-off and saturation modes, corresponding to the "off" and "on" states, respectively, thus behaving like an ideal switch.
Cut-off Mode ("Off" State): In this state, both the emitter-base and collector-base junctions are reverse-biased. The...
Operon Model01:23

Operon Model

The operon model represents a fundamental mechanism of gene regulation in prokaryotes, enabling coordinated expression of genes involved in related metabolic or functional pathways. Operons consist of structural genes, a promoter, and an operator, with transcription regulated by repressors, activators, and small effector molecules.Structure and Function of OperonsAn operon is a cluster of structural genes transcribed together under the control of a single promoter. The promoter region...
Regulation of Expression at Multiple Steps01:23

Regulation of Expression at Multiple Steps

The gene expression in cells is regulated at different stages: (i) transcription, (ii) RNA processing, (iii) RNA localization, and (iv) translation. Transcriptional regulation is mediated by regulatory proteins such as transcription factors, activators, or repressors—these control gene expression by initiating or inhibiting the transcription of genes. Once a precursor or pre-mRNA is produced, it undergoes post-transcriptional modification, including 5' capping, splicing, and the addition of a...
Transient and Steady-state Response01:24

Transient and Steady-state Response

In control systems, test signals are essential for evaluating performance under various conditions. The ramp function is effective for systems undergoing gradual changes, while the step function is suitable for assessing systems facing sudden disturbances. For systems subjected to shock inputs, the impulse function is the most appropriate test signal.
These test signals are integral in designing control systems to exhibit two key performance aspects: transient response and steady-state response.
Root Loci for Positive-Feedback Systems01:23

Root Loci for Positive-Feedback Systems

The Hartley oscillator is a positive feedback system that sustains oscillations by feeding the output back to the input in phase, thereby reinforcing the signal. Positive feedback systems can be viewed as negative feedback systems with inverted feedback signals. In these systems, the root locus encompasses all points on the s-plane where the angle of the system transfer function equals 360 degrees.
The construction rules for the root locus in positive feedback systems are similar to those in...
BIBO stability of continuous and discrete -time systems01:24

BIBO stability of continuous and discrete -time systems

System stability is a fundamental concept in signal processing, often assessed using convolution. For a system to be considered bounded-input bounded-output (BIBO) stable, any bounded input signal must produce a bounded output signal. A bounded input signal is one where the modulus does not exceed a certain constant at any point in time.
To determine the BIBO stability, the convolution integral is utilized when a bounded continuous-time input is applied to a Linear Time-Invariant (LTI) system.