Related Experiment Video
Updated: Aug 13, 2026

Generation and Coherent Control of Pulsed Quantum Frequency Combs
Published on: June 8, 2018
Discrimination of modulation depth of sinusoidal amplitude modulation (SAM) noise
G H Wakefield1, N F Viemeister
1Department of Psychology, University of Minnesota, Minneapolis 55455.
Abstract:
The detection of sinusoidal amplitude modulation (SAM) provides a lower bound on the degree to which temporal information in the envelope of complex waveforms is encoded by the auditory system. The extent to which changes in the amount of modulation are discriminable provides additional information on the ability of the auditory system to utilize envelope fluctuations. Results from an experiment on the discrimination of modulation depth of broadband noise are presented. Discrimination thresholds, expressed as differences in modulation power, increase monotonically with the modulation depth of the standard, but do not obey Weber's law. The effects of carrier level and of modulation frequency are consistent with those observed in modulation detection: Changes in carrier level have little effect on modulation discrimination; changes in modulation frequency also have little effect except for standards near the modulation detection threshold. The discrimination of modulation depth is consistent with the leaky-integrator model of modulation detection for standards below--10 dB (20 log ms); for standards greater than--10 dB, the leaky integrator predicts better performance than that observed behaviorally.
Related Concept Videos
Sinusoidal Sources
In homes, the power supplies use sinusoidal sources to provide electricity. These sources generate a voltage that varies sinusoidally...
Graphical and Analytic Representation of Sinusoids
The first step is measuring the peak-to-peak value, which is twice the amplitude of the sinusoid. This provides information about the maximum voltage swing of the waveform.
Secondly, the period and angular frequency are determined. The period is the time taken for one complete cycle of the waveform, while...
Basic Discrete Time Signals
The unit impulse or sample sequence is mathematically expressed as zero for all n values except at n=0, where it is one. The unit impulse sequence, denoted by δ(n), is the first difference of the unit step sequence, while the unit step sequence u(n) is the...
Sampling Theorem
Aliasing
If the sampling frequency is below the Nyquist rate, these replicas overlap, preventing the original signal...
Upsampling

