Related Experiment Video

Updated: May 25, 2026

Preparation of Human Tissues Embedded in Optimal Cutting Temperature Compound for Mass Spectrometry Analysis
09:09

Preparation of Human Tissues Embedded in Optimal Cutting Temperature Compound for Mass Spectrometry Analysis

Published on: April 27, 2021

Effect of alkyl chain length on sphingosine kinase 2 selectivity

Kenneth Knott1, Yugesh Kharel, Mithun R Raje

  • 1Department of Chemistry, Virginia Tech, Blacksburg, VA 24061, USA.

Bioorganic & Medicinal Chemistry Letters
|February 11, 2012
PubMed

More Related Videos

Quantitative and Qualitative Method for Sphingomyelin by LC-MS Using Two Stable Isotopically Labeled Sphingomyelin Species08:53

Quantitative and Qualitative Method for Sphingomyelin by LC-MS Using Two Stable Isotopically Labeled Sphingomyelin Species

Published on: May 7, 2018

Defining Substrate Specificities for Lipase and Phospholipase Candidates08:59

Defining Substrate Specificities for Lipase and Phospholipase Candidates

Published on: November 23, 2016

Related Concept Videos

Relative Stabilities of Alkenes01:59

Relative Stabilities of Alkenes

The relative stability of alkenes can be determined by comparing their heats of hydrogenation. The lower heat of hydrogenation indicates the more stable alkene.  The three main factors determining the relative stability of alkenes are i) the number of substituents attached to the double-bond carbon atoms, ii) hyperconjugation, and iii) the stereochemistry of the double bond.
Regioselectivity and Stereochemistry of Acid-Catalyzed Hydration02:34

Regioselectivity and Stereochemistry of Acid-Catalyzed Hydration

The rate of acid-catalyzed hydration of alkenes depends on the alkene's structure, as the presence of alkyl substituents at the double bond can significantly influence the rate.
Physical Properties of Alkanes02:33

Physical Properties of Alkanes

Alkanes are nonpolar molecules due to the presence of only carbon and hydrogen atoms. The electronegativity difference between carbon and hydrogen is minimal, and hence alkanes have a zero dipole moment. This leads to the presence of only dispersion forces between the molecules. The strength of dispersion forces is dependent on the surface area of the molecules on which they act. Since the surface area increases with the molecular length for straight-chain alkanes, the dispersion forces also...
Predicting Products: SN1 vs. SN202:27

Predicting Products: SN1 vs. SN2

Nucleophilic substitution reactions of alkyl halides can proceed via an SN1 or an SN2 mechanism. While in SN2 reactions, the nucleophile attacks the substrate simultaneously as the leaving group departs, in SN1 reactions, the substrate first dissociates to give the carbocation intermediate. Various factors such as the structure of the substrate, the strength of the nucleophile, and the nature of the solvent promote one mechanism over the other.
With increased substitution on the alkyl halide,...
Regioselectivity of Electrophilic Additions to Alkenes: Markovnikov's Rule02:17

Regioselectivity of Electrophilic Additions to Alkenes: Markovnikov's Rule

If a set of reactants can yield multiple constitutional isomers, but one of the isomers is obtained as the major product, the reaction is said to be regioselective. In such reactions, bond formation or breaking is favored at one reaction site over others.
The hydrohalogenation of an unsymmetrical alkene can yield two haloalkane products, depending on which vinylic carbon takes up the halogen. However, one product usually predominates, where hydrogen adds to the vinylic carbon bearing the...
Acidity of 1-Alkynes02:42

Acidity of 1-Alkynes


The acidic strength of hydrocarbons follows the order: Alkynes > Alkenes > Alkanes. The strength of an acid is commonly expressed in units of pKa — the lower the pKa, the stronger the acid. Among the hydrocarbons, terminal alkynes have lower pKa values and are, therefore, more acidic. For example, the pKa values for ethane, ethene, and acetylene are 51, 44, and 25, respectively, as shown here.