Insights into structural properties of denatured human prion 121-230 at melting temperature studied by replica

Jaw-Luen Tang1, Po-Jen Wu, Shing-Chuen Wang

  • 1Department of Physics, National Chung Cheng University, Ming-Hsiung Chia-Yi, Taiwan 62102, ROC.

Related Concept Videos

Protein Denaturation01:28

Protein Denaturation

The function of proteins depends on their native three-dimensional structure, which is dictated by the amino acid sequence of the specific protein. Folding of the polypeptide chain takes place under specific conditions that energetically favor the folded conformation. In contrast, protein denaturation occurs spontaneously under unfavorable conditions that disrupt the integrity of the folded conformation. Thus, the chemical and physical environment of a protein, such as significant changes in pH...
Amyloid Fibrils03:03

Amyloid Fibrils

Amyloid fibrils are aggregates of misfolded proteins.  Under most circumstances, misfolded proteins are either refolded by chaperone proteins or degraded by the proteasome. However, in the case of a mutation or a disease, these proteins can accumulate to form large clusters and often further assemble to form elongated fibers, called fibrils. 
Amyloid deposits were observed as early as 1639 in the liver and the spleen.   In 1854, Rudolph Virchow performed iodine staining, normally used to...
Molecular Chaperones and Protein Folding03:00

Molecular Chaperones and Protein Folding

The native conformation of a protein is formed by interactions between the side chains of its constituent amino acids. When the amino acids cannot form these interactions, the protein cannot fold by itself and needs chaperones. Notably, chaperones do not relay any additional information required for the folding of polypeptides; the native conformation of a protein is determined solely by its amino acid sequence. Chaperones catalyze protein folding without being a part of the folded protein.
The...
Phase Transitions: Melting and Freezing02:39

Phase Transitions: Melting and Freezing

Heating a crystalline solid increases the average energy of its atoms, molecules, or ions, and the solid gets hotter. At some point, the added energy becomes large enough to partially overcome the forces holding the molecules or ions of the solid in their fixed positions, and the solid begins the process of transitioning to the liquid state or melting. At this point, the temperature of the solid stops rising, despite the continual input of heat, and it remains constant until all of the solid is...