Related Experiment Video

Updated: May 24, 2026

A Simple Approach to Perform TEER Measurements Using a Self-Made Volt-Amperemeter with Programmable Output Frequency
07:43

A Simple Approach to Perform TEER Measurements Using a Self-Made Volt-Amperemeter with Programmable Output Frequency

Published on: October 5, 2019

[Discussion of leakage current measurement earthing]

Yuming Li1, Jian Zhou

  • 1Jiangsu Information Institute of Science and Technology, Nanjing, 210042. YXYQ@sti.js.cn

Zhongguo Yi Liao Qi Xie Za Zhi = Chinese Journal of Medical Instrumentation
|March 3, 2012
PubMed

More Related Videos

Measurement of Bioelectric Current with a Vibrating Probe07:28

Measurement of Bioelectric Current with a Vibrating Probe

Published on: January 4, 2011

Electrophysiological Recordings of Single-cell Ion Currents Under Well-defined Shear Stress07:17

Electrophysiological Recordings of Single-cell Ion Currents Under Well-defined Shear Stress

Published on: August 2, 2019

Related Concept Videos

Kirchhoff's Current Law01:04

Kirchhoff's Current Law

In the realm of electrical engineering, physicist Gustav Robert Kirchhoff made a significant contribution in 1847 by introducing Kirchhoff's laws for electric circuit analysis. These laws, particularly Kirchhoff's Current Law (KCL), have become foundational principles in understanding and analyzing electrical circuits.
Kirchhoff's Current Law is based on the principle of charge conservation. It states that at any node (a point where two or more circuit elements meet) in an electrical circuit,...
Boundary Conditions for Current Density01:25

Boundary Conditions for Current Density

Current density becomes discontinuous across an interface of materials with different electrical conductivities. The normal component of the current density is continuous across the boundary.
Ammeter01:11

Ammeter

An ammeter is a current measuring instrument. In the circuit, it is represented by the symbol A. The ammeter is placed in series with the device or component to measure the current. A series connection is used because objects in series have the same current passing through them. If a circuit has multiple resistors and the current needs to be measured in each resistor, the number of ammeters required depends on whether the circuit is in series or parallel.
When an ammeter is used to measure the...
Electrical Current01:10

Electrical Current

Electrical current is defined as the rate at which charge flows. When there is a large current present, such as that used to run a refrigerator, a large amount of charge moves through the wire in a small amount of time. If the current is small, such as that used to operate a handheld calculator, a small amount of charge moves through the circuit over a long period of time. The SI unit for current is the ampere (A), named for the French physicist André-Marie Ampère (1775–1836). An ampere is the...
Calculation of Self-inductance01:29

Calculation of Self-inductance

The self-inductance of a circuit, often simply called the inductance, is a purely geometric factor that depends only on the circuit component's structure. More specifically, it depends on the shape and size of the component that lets the flux pass through it, thus inducing an electric field that opposes any current passing through it.
Since the effect of the induced electric field and the back EMF generated depends on the rate of change of current and the self-inductance, the inductance...
Series R—L Circuit Transients01:22

Series R—L Circuit Transients

In a series resistor-inductor (R-L) circuit, closing the switch at the start of the time period simulates a three-phase short circuit, a fault condition where all three phases of an unloaded synchronous machine are short-circuited. When there is no fault impedance and no initial current, the initial voltage is determined by the phase angle of the source voltage.
Using Kirchhoff's Voltage Law (KVL) to analyze this circuit helps determine the total asymmetrical fault current, which consists of...