Related Experiment Video
Updated: May 23, 2026

Measurement of Greenhouse Gas Flux from Agricultural Soils Using Static Chambers
Published on: August 3, 2014
Systematic evaluation of land use regression models for NO₂
Meng Wang1, Rob Beelen, Marloes Eeftens
1Institute for Risk Assessment Sciences (IRAS), Division of Environmental Epidemiology, Utrecht University, Utrecht, The Netherlands.
Abstract:
Land use regression (LUR) models have become popular to explain the spatial variation of air pollution concentrations. Independent evaluation is important. We developed LUR models for nitrogen dioxide (NO(2)) using measurements conducted at 144 sampling sites in The Netherlands. Sites were randomly divided into training data sets with a size of 24, 36, 48, 72, 96, 108, and 120 sites. LUR models were evaluated using (1) internal "leave-one-out-cross-validation (LOOCV)" within the training data sets and (2) external "hold-out" validation (HV) against independent test data sets. In addition, we calculated Mean Square Error based validation R(2)s. The mean adjusted model and LOOCV R(2) slightly decreased from 0.87 to 0.82 and 0.83 to 0.79, respectively, with an increasing number of training sites. In contrast, the mean HV R(2) was lowest (0.60) with the smallest training sets and increased to 0.74 with the largest training sets. Predicted concentrations were more accurate in sites with out of range values for prediction variables after changing these values to the minimum or maximum of the range observed in the corresponding training data set. LUR models for NO(2) perform less well, when evaluated against independent measurements, when they are based on relatively small training sets. In our specific application, models based on as few as 24 training sites, however, achieved acceptable hold out validation R(2)s of, on average, 0.60.
Related Concept Videos
Multiple Regression
Farmers can use multiple regression to determine the crop yield based on more than one factor, such as water availability, fertilizer, soil properties, etc. Here, the crop yield is the response or dependent variable as it depends on the other independent variables. The analysis requires the construction of a scatter plot...
Regression Analysis
In regression analysis, a regression equation is determined based on the line of best fit– a line that best fits the data points plotted in a graph. This line is also called the regression line. The algebraic equation for the regression line is called the regression equation. It is represented as:
Residuals and Least-Squares Property
If the observed data point lies above the line, the residual is positive, and the line underestimates the actual data value for y. If the observed data point lies below the line, the residual is negative, and the line overestimates the actual data value for y.
The process of fitting the best-fit...
Parameters Affecting Nonlinear Elimination: Zero-Order Input, First-Order Absorption and Two-Compartment Model
When a drug is administered through a constant intravenous infusion and eliminated via nonlinear pharmacokinetics, it follows zero-order input. For example, oral drugs undergo first-order absorption upon administration and are eliminated through nonlinear pharmacokinetics.
In the case of subcutaneously administered drugs,...
Residual Plots
When the residual values are plotted against the variable x, it is called a residual...
Mechanistic Models: Compartment Models in Individual and Population Analysis

