Estimation of genetic variation in residual variance in female and male broiler chickens

H A Mulder1, W G Hill, A Vereijken

  • 11Animal Breeding and Genomics Centre, Animal Sciences Group, PO Box 65, 8200 AB Lelystad, The Netherlands.

Related Concept Videos

Genetic Variation01:25

Genetic Variation

Genetic variation is the diversity in DNA sequences found among individuals of the same species. This diversity is crucial for a species' survival because it helps organisms adapt to environmental changes. Genetic variation begins with fertilization, where an egg and sperm cell merge. Each of these cells carries 23 chromosomes, up to 46 in the fertilized egg. Chromosomes are long DNA strands that contain genes, the basic units of heredity.
Genes exist in different versions called alleles, which...
The Ratio of X Chromosome to Autosomes02:45

The Ratio of X Chromosome to Autosomes

In most organisms, sex is determined by the ratio of X and Y chromosomes. However, in some organisms, such as Drosophila and C.elegans, sex is determined by the ratio of the number of X chromosomes to the number of sets of autosomes. The Y chromosome in Drosophila is active but does not determine sex. It contains genes responsible for the production of sperms in adult flies.  
Normal male Drosophila has a ratio of one X chromosome to two sets of autosomes. In contrast, normal female Drosophila...
Hardy-Weinberg Principle01:49

Hardy-Weinberg Principle

Diploid organisms have two alleles of each gene, one from each parent, in their somatic cells. Therefore, each individual contributes two alleles to the gene pool of the population. The gene pool of a population is the sum of every allele of all genes within that population and has some degree of variation. Genetic variation is typically expressed as a relative frequency, which is the percentage of the total population that has a given allele, genotype or phenotype.
Testing a Claim about Mean: Unknown Population SD01:21

Testing a Claim about Mean: Unknown Population SD

A complete procedure of testing a hypothesis about a population mean when the population standard deviation is unknown is explained here.
Estimating a population mean requires the samples to be approximately normally distributed. The data should be collected from the randomly selected samples having no sampling bias. There is no specific requirement for sample size. But if the sample size is less than 30, and we don't know the population standard deviation, a different approach is used; instead...
Chi-square Analysis02:46

Chi-square Analysis

The chi-square test is a statistical hypothesis test. It is used to check whether there is a significant difference between an expected value and an observed value. In the context of genetics, it enables us to either accept or reject a hypothesis, based on how much the observed values deviate from the expected values.
The chi-square test was developed by Pearson in 1990.
The first step of performing a Chi-square analysis is to establish a null hypothesis, which assumes that there is no real...
Variation01:19

Variation

An important characteristic of any set of data is the variation in the data. In some data sets, the data values are concentrated closely near the mean; in other data sets, the data values are more widely spread out from the mean. The most common measure of variation, or spread, is the standard deviation, which is the square root of variance.
When independent and dependent variables are plotted on a scatter plot, the slope of a line is a value that describes the rate of change between the two...