Related Experiment Video
Updated: May 23, 2026

Measurements of Waves in a Wind-wave Tank Under Steady and Time-varying Wind Forcing
Published on: February 13, 2018
Multi-parameter identification from scalar time series generated by a Malkus-Lorenz water wheel
Lucas Illing1, Alison M Saunders, Daniel Hahs
1Department of Physics, Reed College, Portland, Oregon 27708, USA. illing@reed.edu
Abstract:
We address the issue of multi-parameter estimation from scalar outputs of chaotic systems, using the dynamics of a Malkus water wheel and simulations of the corresponding Lorenz-equations model as an example. We discuss and compare two estimators: one is based on a globally convergent adaptive observer and the second is an extended Kalman filter (EKF). Both estimators can identify all three unknown parameters of the model. We find that the estimated parameter values are in agreement with those obtained from direct measurements on the experimental system. In addition, we explore the question of how to distinguish the impact of noise from those of model imperfections by investigating a model generalization and the use of uncertainty estimates provided by the extended Kalman filter. Although we are able to exclude asymmetric inflow as a possible unmodeled effect, our results indicate that the Lorenz-equations do not perfectly describe the water wheel dynamics.
Related Concept Videos
Linear Approximation in Time Domain
For a simple pendulum with a mass evenly distributed along its length and the center of mass located at half the pendulum's length, the...
Mechanistic Models: Compartment Models in Individual and Population Analysis
Wind Turbine Machine Models
Induction machines interact through the rotating magnetic field generated by the stator and the rotor. The key parameter is slip, which is the difference between synchronous speed and rotor speed relative to synchronous speed. Slip is...
Design Example: Creating a Hydraulic Model of a Dam Spillway
Wave Parameters
Multimachine Stability
In analyzing the system, the nodal equations represent the relationship between bus voltages, machine voltages, and machine currents. The nodal equation is given by: