Related Experiment Video
Updated: May 23, 2026

Fabrication of polydimethylsiloxane (PDMS)-Based Flexible Surface-Enhanced Raman Scattering (SERS) Substrate for Ultrasensitive Detection
Published on: November 17, 2023
Determination of tricyclazole content in paddy rice by surface enhanced Raman spectroscopy
Huirong Tang1, Dongmei Fang, Qingqing Li
1Shanghai Key Laboratory of Functional Materials Chemistry, and Research Centre of Analysis and Test, East China Univ. of Science and Technology, Meilong Rd 130, Shanghai 200237, China.
Abstract:
An ultrasensitive method based on Surface enhanced Raman scattering (SERS) has been developed to determine content of a pesticide which is tricyclazole in paddy rice using sliver colloid as a substrate and pyridine as an internal standard. The peaks at 424 and 1035 cm(-1) in a SERS spectrum were selected as analytic and internal peaks, respectively, and their intensity ratio I(t)/I(p) was used to calculate the regression concentration of tricyclazole. The correlation between I(t)/I(p) and concentration showed significant linear relationship with a correlation coefficient of R(2)= 0.995 in a concentration range of 0.05 to 0.70 mg/L and the tricyclazole solution can be detected to be low as 0.002 mg/L by SERS. The method was applied to determine tricyclazole contents of 3 real rice samples with a standard addition method in order to eliminate interference of matrix. The errors of SERS measurements for the 3 samples were 0.0008 to 0.0246, 0.0013 to 0.0028, and 0.0129 to 0.0304 mg/kg, respectively, compared with the results obtained by high performance liquid chromatography method. This also showed a good reproducibility with low values of relative standard deviation (n= 3) for the 3 samples ranged from 3.63% to 4.64%.
Related Concept Videos
Raman Spectroscopy: Overview
However, a small fraction of the scattered light exhibits a frequency shift due to the exchange of energy between the incident photons and the...
Raman Spectroscopy Instrumentation: Overview
The monochromatic laser source, typically using visible or near-infrared radiation, generates a highly focused beam of light. This light interacts with the molecules of the sample, scattering some of the light. Liquid and gaseous samples are usually tested in ordinary glass capillaries, while solids can be analyzed as powders packed in capillaries or as potassium...
Attenuated Total Reflectance (ATR) Infrared Spectroscopy: Overview
The ATR process begins by directing a beam...
