Related Experiment Video

Updated: May 23, 2026

Construction of a Low-cost Mobile Incubator for Field and Laboratory Use
07:50

Construction of a Low-cost Mobile Incubator for Field and Laboratory Use

Published on: March 19, 2019

Emergency water supply: a review of potential technologies and selection criteria

Siew-Leng Loo1, Anthony G Fane, William B Krantz

  • 1Singapore Membrane Technology Centre, Nanyang Technological University, Singapore 639798, Singapore.

Water Research
|April 24, 2012
PubMed

More Related Videos

Continuous Instream Monitoring of Nutrients and Sediment in Agricultural Watersheds12:50

Continuous Instream Monitoring of Nutrients and Sediment in Agricultural Watersheds

Published on: September 26, 2017

Spatial Multiobjective Optimization of Agricultural Conservation Practices using a SWAT Model and an Evolutionary Algorithm11:53

Spatial Multiobjective Optimization of Agricultural Conservation Practices using a SWAT Model and an Evolutionary Algorithm

Published on: December 9, 2012

Related Concept Videos

Design Example: Analyzing Capacity Contours for Flood Risk Assessment01:17

Design Example: Analyzing Capacity Contours for Flood Risk Assessment

Flood risk assessment involves careful planning and analysis to ensure the safety of communities near water retention structures. Capacity contours are a vital tool in this process, as they illustrate the potential spread of water at specific levels in a given area. In the context of building a bund across a small valley, these contours play a critical role in evaluating the safety of nearby residential areas.In this example, the bund is intended to store stormwater in the valley. The engineers...
Design Example: Designing a Residential Plumbing System01:25

Design Example: Designing a Residential Plumbing System

The design of residential plumbing systems requires carefully evaluating water demand, flow rates, and pressure dynamics to ensure both efficiency and reliability. The nature of water flow within pipes is defined by its Reynolds number, which classifies flow as either laminar (smooth) or turbulent.
Design Example: Design of an Irrigation Channel01:27

Design Example: Design of an Irrigation Channel

Trapezoidal channels are widely used in irrigation systems due to their cost-effectiveness and efficiency in conveying water. Trapezoidal channels feature a flat bottom and sloping sides, making them stable and easier to construct compared to other shapes. The bottom width and side slope ratio are determined based on the required flow capacity and site conditions. The side slope is kept gentle for unlined channels to prevent soil erosion.Hydraulic parameters in channel design include the flow...
Precipitation and Co-precipitation01:17

Precipitation and Co-precipitation

Precipitation and coprecipitation methods can be used to separate a mixture of ions in a solution. In qualitative inorganic analysis, ions that form sparingly soluble precipitates with the same reagent are separated based on the differences in solubility products. For example, consider the separation of Cu(II) and Fe(II) ions by precipitation as insoluble sulfides. First, copper(II) sulfide is precipitated by the addition of acidic H2S, where the dissociation of H2S is suppressed. Adding H2S...
Regulation of Water Intake01:25

Regulation of Water Intake

Osmolality refers to the number of solute particles per kilogram of solvent in a solution. Plasma osmolality specifically indicates the total number of solute particles per kilogram of water in blood plasma. This value reflects the body's hydration status and is tightly regulated through mechanisms controlling water intake and output. While water consumption is a conscious decision, the body has intrinsic regulatory systems to maintain fluid balance. Dehydration, a state of water deficit...
States of Water01:23

States of Water

Water exists in any one of the three classical states: solid (ice), liquid (water), and gas (steam or water vapor). The state of water depends on i) the intermolecular forces that draw molecules together and ii) the kinetic energy that leads to movements that pull them apart.
Water freezes when the intermolecular forces are greater than the kinetic energy. Unlike most other substances, water is less dense in its solid state than in its liquid state. This is because each water molecule can form...