Electrocoagulation versus chemical coagulation: coagulation/flocculation mechanisms and resulting floc...

Electrocoagulation (EC) and chemical coagulation (CC) are employed in water treatment for particle removal. Although both are used for similar purposes, they differ in their dosing method - in EC the coagulant is added by electrolytic oxidation of an appropriate anode material, while in CC dissolution of a chemical coagulant is used. These different methods in fact induce different chemical environments, which should impact coagulation/flocculation mechanisms and subsequent floc formation. Hence, the process implications when choosing which to apply should be significant. This study elucidates differences in coagulation/flocculation mechanisms in EC versus CC and their subsequent effect on floc growth kinetics and structural evolution. A buffered kaolin suspension served as a representative solution that underwent EC and CC by applying aluminum via additive dosing regime in batch mode. In EC an aluminum anode generated the active species while in CC, commercial alum was used. Aluminum equivalent doses were applied, at initial pH values of 5, 6.5 and 8, while samples were taken over pre-determined time intervals, and analyzed for pH, particle size distribution, ζ potential, and structural properties. EC generated fragile flocs, compared to CC, over a wider pH range, at a substantially higher growth rate, that were prone to restructuring and compaction. The results suggest that the flocculation mechanism governing EC in sweep floc conditions is of Diffusion Limited Cluster Aggregation (DCLA) nature, versus a Reaction Limited Cluster Aggregation (RLCA) type in CC. The implications of these differences are discussed.