Association between perceived union connection and upper body musculoskeletal pains among unionized construction

Seung-Sup Kim1, Melissa J Perry, Cassandra A Okechukwu

  • 1Department of Environmental and Occupational Health, The George Washington University School of Public Health and Health Services, Washington, District of Columbia. sskim@gwu.edu

Abstract

Related Concept Videos

Method of Joints01:30

Method of Joints

The method of joints is a commonly used technique to analyze the forces in structural trusses. The method is based on the principle of equilibrium, which assumes that the truss members are connected by frictionless pins. The forces at each joint can be determined by considering the equilibrium of the forces acting on that joint.
Since plane truss members are in the same plane, each joint is subjected to a coplanar and concurrent force system. To apply the method of joints, the first step is to...
Blood and Nerve Supply to the Bones01:29

Blood and Nerve Supply to the Bones

Bones are dynamic organs that require a rich supply of oxygen and nutrients. Around 5% to 10% of the cardiac output supplies blood to the bones. A typical long bone has three main sources: the nutrient artery, the metaphyseal and epiphyseal arteries, and the periosteal arteries.
Nutrient Artery
The nutrient artery is the main blood vessel that enters the diaphysis via the nutrient foramen. While most long bones have only one nutrient foramen, large bones, such as the femur, may have two. This...
Method of Joints: Problem Solving II01:30

Method of Joints: Problem Solving II

Consider a truss structure with frictionless joints fixed to a wall and roller support. If a force of 150 N is applied to joint A, the forces in each member of the truss can be determined using the method of joints.
Method of Joints: Problem Solving I01:30

Method of Joints: Problem Solving I

The method of joints is a commonly used technique to analyze the forces in structural trusses. The method is based on the principle of equilibrium, which assumes that the truss members are connected by frictionless pins. The forces at each joint can be determined by considering the equilibrium of the forces acting on that joint. Consider a truss structure with two forces of 20 N and 10 N acting at joints C and D, respectively. The method of joints can be used to determine the forces FCB, FDC,...