Degree of conversion of nano-hybrid resin-based composites with novel and conventional matrix formulation

This study aimed to determine the degree of conversion (DC) of two nano-hybrid resin-based composites (RBCs) with novel monomer composition based on dimer acid derivates (hydrogenated dimer acid) and tricyclodecane-urethane structure compared to three nano-hybrid materials containing conventional matrices. DC was evaluated at 0.1, 2, and 6 mm depth at varying irradiation times (10, 20, and 40 s) and layering techniques (bulk and incremental).

DC was measured in real time by a Fourier transform infrared spectroscopy (FTIR) spectrometer with attenuated total reflectance accessory. The FTIR spectra were recorded on the bottom of the samples in real time for 5 min from photoinitiation. Results were compared using one- and multiple-way ANOVA, Tukey's HSD post hoc test (α = 0.05), and partial eta-squared statistic.

After 5 min of measurement, DC showed no significant difference by varying cure time for specimens of 0.1 mm thickness. At 2 mm depth, the DC significantly increased after a cure time of 20 s compared to 10 s, remaining equal after 40 s of irradiation. At 6 mm depth, bulk curing showed significantly lower DC compared to incremental curing for all polymerization times. Specimen geometry revealed a strong effect on DC (η (2) = 0.90) followed by curing time (η (2) = 0.39).

The RBCs containing the dimer acid and tricyclodecane-urethane structure showed a relatively low decrease of DC with increasing incremental thickness compared to the conventionally formulated materials. The former reached the highest DC among the tested materials.

For the tested RBCs, increments of 2 mm and irradiation time of at least 20 s may be recommended for clinical practice. The two materials containing novel monomer composition might be applied for enlarged increments because of the low decrease of DC they demonstrated for 6-mm increments.