Related Experiment Video

Updated: May 22, 2026

Safety Precautions and Operating Procedures in an (A)BSL-4 Laboratory: 2. General Practices
08:53

Safety Precautions and Operating Procedures in an (A)BSL-4 Laboratory: 2. General Practices

Published on: October 3, 2016

Safety practices in Jordanian manufacturing enterprises within industrial estates

Samir Khrais1, Omar Al-Araidah, Assaf Mohammad Aweisi

  • 1a Department of Industrial Engineering , Jordan University of Science and Technology , Irbid , Jordan.

International Journal of Injury Control and Safety Promotion
|May 18, 2012
PubMed

More Related Videos

Simulation of a Scaled Assembly Process with Collaboration of a Robotic Arm and Monitoring through a Vision System for Quality Control05:47

Simulation of a Scaled Assembly Process with Collaboration of a Robotic Arm and Monitoring through a Vision System for Quality Control

Published on: August 29, 2025

Related Concept Videos

Steel Manufacturing01:26

Steel Manufacturing

Steel manufacturing is a multi-stage process that begins by smelting iron ore into cast iron in a blast furnace. This initial stage involves layering iron ore with coke, a type of fuel, and crushed limestone within the furnace. The coke is ignited with a high volume of air, leading to the creation of carbon monoxide, which acts to reduce the iron ore to pure iron.
During this smelting process, limestone plays a crucial role by forming slag. Slag captures impurities within the molten iron, such...
Healthcare Associated Infections II: Preventive Measures01:22

Healthcare Associated Infections II: Preventive Measures

Essential infection prevention measures are based on the knowledge of the infection chain, the modes of transmission in healthcare settings, and the use of the best practices in all healthcare settings. Compulsory public reporting of healthcare-associated infection rates is needed to allow individuals and the community to make informed choices regarding selecting a healthcare facility.
The best practices for preventing healthcare-associated infections include hand hygiene, patient risk...
Factors Affecting Workability01:24

Factors Affecting Workability

The workability of concrete is a critical characteristic that influences the ease of mixing, handling, and finishing the concrete. It is affected by several factors including water content, aggregate properties, and admixtures like air entrainment. Water plays a fundamental role as it lubricates the concrete mix, facilitating easier movement and placement. However, the water requirement varies depending on the texture and shape of aggregates. Finer particles and angular, rough-textured...
Personal Protective Equipment01:20

Personal Protective Equipment

Personal protective equipment (PPE) is unique clothing or equipment worn by an employee to minimize or prevent exposure to infectious agents. PPE creates a barrier between the employee and the infectious materials. PPE must be readily available in the patient care area. PPE includes gloves, gowns and aprons, masks and respirators, goggles, face shields, shoes, and headcovers:
Household Wiring And Electrical Safety01:13

Household Wiring And Electrical Safety

Companies that supply power to most modern households use three conductors, typically called a three-wire line. While one is neutral, the other two are both at 120 V but with opposite polarity, giving a voltage of 240 V between them. With a three-wire line, high-power appliances that require 240 V, such as electric stoves and clothes dryers, are linked between the two hot lines. 120 V appliances can be connected between the neutral and either of the hot lines. The neutral side, which is always...
Stress Concentrations in Circular Shafts01:18

Stress Concentrations in Circular Shafts

Consider the elastic torsion formula, which applies to a circular shaft with a consistent cross-section. This formula assumes that the shaft's ends are loaded with rigid plates firmly attached. However, in many cases, torques are applied to the shaft through mechanisms like flange couplings or gears, which are connected by keys inserted into keyways. This application method modifies the stress distribution near the point of torque application, causing it to deviate from the distributions...