Optimization of staining conditions for microalgae with three lipophilic dyes to reduce precipitation and...

When the fluorescence signal of a dye is being quantified, the staining protocol is an important factor in ensuring accuracy and reproducibility. Increasingly, lipophilic dyes are being used to quantify cellular lipids in microalgae. However, there is little discussion about the sensitivity of these dyes to staining conditions. To address this, microalgae were stained with either the lipophilic dyes often used for lipid quantification (Nile Red and BODIPY) or a lipophilic dye commonly used to stain neuronal cell membranes (DiO), and fluorescence was measured using flow cytometry. The concentration of the cells being stained was found not to affect the fluorescence. Conversely, the concentration of dye significantly affected the fluorescence intensity from either insufficient saturation of the cellular lipids or formation of dye precipitate. Precipitates of all three dyes were detected as events by flow cytometry and fluoresced at a similar intensity as the chlorophyll in the microalgae. Prevention of precipitate formation is, therefore, critical to ensure accurate fluorescence measurement with these dyes. It was also observed that the presence of organic solvents, such as acetone and dimethyl sulfoxide (DMSO), were not required to increase penetration of the dyes into cells and that the presence of these solvents resulted in increased cellular debris. Thus, staining conditions affected the fluorescence of all three lipophilic dyes, but Nile Red was found to have a stable fluorescence intensity that was unaffected by the broadest range of conditions and could be correlated to cellular lipid content.