Related Experiment Video
Updated: May 21, 2026

Nanostructured Ag-zeolite Composites as Luminescence-based Humidity Sensors
Published on: November 15, 2016
Note: response characteristics of the sensor based on LaF3 thin film to different humidified gases
Guoliang Sun1, Hairong Wang, Zhuangde Jiang
1State Key Laboratory for Manufacturing Systems Engineering, Xi'an Shaanxi 710049, People's Republic of China.
Abstract:
Electromotive force (EMF) transient curves presented that the sensor showed good repeatable response in the humidity environments using ambient atmosphere as the carrier gas at different temperatures. The 90% response time and recovery time were within 40 s and 50 s, respectively. The sensor also presented stable response characteristics in 75.1% RH and 83.6% RH humidity environments using N(2), 5% O(2), and 50% O(2) as the carrier gases, respectively. The EMF always increased with the partial pressure of oxygen in certain relative humidity. However, the ΔEMF was decreased with the increase of O(2) content in the carrier gas under the condition of the variation of relative humidity from 75.1% to 83.6%. These phenomena revealed that the sensor was sensitive to water vapor without oxygen in the sample gas and too much water vapor had adverse effect on the response to oxygen. Non-Nernst behavior of the sensor was discussed in detail.
Related Concept Videos
Gas Chromatography: Types of Detectors-II
Gas Chromatography: Types of Detectors-I
TCD is the earliest and most widely used detector that operates by measuring the changes in the thermal conductivity of the carrier gas. When a sample compound enters the detector,...
