Nonlinear finite element analysis of three implant- abutment interface designs

The objective of this study was to investigate the mechanical characteristics of implant-abutment interface design in a dental , using nonlinear finite element analysis (FEA) method. This finite element simulation study was applied on three commonly used commercial dental implant systems: model I, the reduced-diameter 3i implant system (West Palm Beach, FL, USA) with a hex and a 12-point double internal hexagonal connection; model II, the Semados implant system (Bego, Bremen, Germany) with combination of a conical (450 taper) and internal hexagonal connection; and model III, the Brinemark implant system (Nobel Biocare, Gothenburg,Sweden) with external hexagonal connection. In simulation, a force of 170 N with 45" oblique to the longitudinal axis of the implant was loaded to the top surface of the abutment. It has been found from the strength and stiffness analysis that the 3i implant system has the lowest maximum von Mises stress, principal stress and displacement while the Br Bnemark implant system has the highest. It was concluded from our preliminary study using nonlinear FEA that the reduced-diameter 3i implant system with a hex and a 12-point double internal hexagonal connection had a better stress distribution, and produced a smaller displacement than the other two implant systems.