Related Experiment Video
Updated: May 21, 2026

20 mJ, 1 ps Yb:YAG Thin-disk Regenerative Amplifier
Published on: July 12, 2017
Q-switched induced gain switching of a two-transition cascade laser
Jianfeng Li1, Tomonori Hu, Stuart D Jackson
1Institute of Photonics and Optical Science and the Centre for Ultrahigh Bandwidth Devices for Optical Systems (CUDOS), School of Physics, University of Sydney, Camperdown 2006, Australia. lijianfeng@uestc.edu.cn
Abstract:
A gain-switched laser transition, of a two-laser-transition cascade laser, that is driven by the adjacent laser transition which is Q-switched is demonstrated using a Ho3+-doped fluoride fiber laser. Q-switching the 5I6 → 5I7 transition at 3.002 µm produces stable gain-switched pulses from the 5I7 → 5I8 transition at 2.074 µm; however, Q-switching the 5I7 → 5I8 transition produced multiple gain switched pulses from the 5I6 → 5I7 transition. The gain-switched pulses were measured to be of a similar duration to the Q-switched pulses suggesting that much shorter pulses of closer duration could be generated at pump power higher levels.
More Related Videos
Related Concept Videos
Cascaded Op Amps
In a cascaded system, each op-amp is referred to as a stage. The output of one stage drives the input of the subsequent stage. As the input signal passes through...
Switching of BJT
Cut-off Mode ("Off" State): In this state, both the emitter-base and collector-base junctions are reverse-biased. The...
MOSFET: Enhancement Mode
In their basic form, enhancement-mode MOSFETs are typically non-conductive when the gate-source voltage (Vgs) is zero. This default 'off' state means no current...
MOSFET Amplifiers
Small-Signal Analysis of MOSFET Amplifiers

