Related Experiment Video
Updated: May 21, 2026

Integrating a Triplet-triplet Annihilation Up-conversion System to Enhance Dye-sensitized Solar Cell Response to Sub-bandgap Light
Published on: September 12, 2014
Utilizing photocurrent transients for dithiolene-based photodetection: stepwise improvements at communications
Simon Dalgleish1, Michio M Matsushita, Laigui Hu
1Department of Chemistry and Research Centre for Materials Science, Nagoya University, Chikusa, Nagoya, Japan. dalgleish.simon.john@j.mbox.nagoya-u.ac.jp
Abstract:
Photodetection based on bis-(4-dimethylaminodithiobenzil)-Ni(II) (BDN), a representative and well-studied metal dithiolene that shows strong absorption in the near-infrared region of the electromagnetic spectrum, has been investigated. By adopting a metal/insulator/semiconductor/metal (MISM) structure, the peak photocurrent response to an oscillating light chain is increased by up to 50 times, compared to devices without an insulating layer. The transient form of the MISM photoresponse, while unsuitable for steady-state photodetection, can be used to detect periodic light signals of frequencies up to 1 MHz, and is thus applicable for optical communication. Further improvements have been realized by nanostructuring carbon black into the dithiolene layer, improving charge collection, and yielding detectivity of up to 1.6 × 10(11) Jones at wavelengths beyond the scope of silicon photodiodes. Such an architecture may allow the favorable absorption properties of other such metal dithiolenes to be harnessed, where their low charge carrier mobilities and short excitation lifetimes have previously limited their applicability to this field.
More Related Videos
11:30Recombination Dynamics in Thin-film Photovoltaic Materials via Time-resolved Microwave Conductivity
Published on: March 6, 2017
06:08Time-resolved Photophysical Characterization of Triplet-harvesting Organic Compounds at an Oxygen-free Environment Using an iCCD Camera
Published on: December 27, 2018