Acid-base equilibriums of lumichrome and its 1-methyl, 3-methyl, and 1,3-dimethyl derivatives
Related Experiment Video
Updated: May 21, 2026

Blue-hazard-free Candlelight OLED
Published on: March 19, 2017
Dorota Prukała1, Ewa Sikorska, Jacek Koput
1Faculty of Chemistry, A. Mickiewicz University, Grunwaldzka 6, 60-780 Poznań, Poland. dprukala@amu.edu.pl
Abstract:
Lumichrome photophysical properties at different pH were characterized by UV-vis spectroscopy and steady-state and time-resolved fluorescence techniques, in four forms of protonation/deprotonation: neutral form, two monoanions, and dianion. The excited-state lifetimes of these forms of lumichrome were measured and discussed. The results were compared to those obtained for similar forms of alloxazine and/or isoalloxazine, and also to those of 1-methyl- and 3-methyllumichrome and 1,3-dimethyllumichrome. The absorption, emission, and synchronous spectra of lumichrome, 1-methyl- and 3-methyllumichrome, and 1,3-dimethyllumichrome at different pH were measured and used in discussion of fluorescence of neutral and deprotonated forms of lumichrome. The analysis of steady-state and time-resolved spectra and the DFT calculations both predict that the N(1) monoanion and the N(1,3) dianion of lumichrome have predominantly isoalloxazinic structures. Additionally, we confirmed that neutral lumichrome exists in its alloxazinic form only, in both the ground and the excited state. We also confirmed the existence and the alloxazinic structure of a second N(3) monoanion. The estimated values of pK(a) = 8.2 are for the equilibrium between neutral lumichrome and alloxazinic and isoalloxazinic monoanions, with proton dissociation from N(1)-H and N(3)-H groups proceeding at the almost the same pH, while the second value pK(a) = 11.4 refers to the formation of the isoalloxazinic dianion in the ground state.
More Related Videos
06:06A Simple Dewar/Cryostat for Thermally Equilibrating Samples at Known Temperatures for Accurate Cryogenic Luminescence Measurements
Published on: July 19, 2016
14:11Synthesis of pH Dependent Pyrazole, Imidazole, and Isoindolone Dipyrrinone Fluorophores using a Claisen-Schmidt Condensation Approach
Published on: June 10, 2021
Related Concept Videos
Ladder Diagrams: Acid–Base Equilibria
A ladder diagram for acid-base equilibria consists of a vertical axis that represents pH and horizontal bars (steps on the ladder) that help position all the pKa values in the system. At equilibrium, the pH value of the system corresponds to one of...
Strong Acid and Base Solutions
Titration of Polyprotic Base with a Strong Acid
Acidity of 1-Alkynes
The acidic strength of hydrocarbons follows the order: Alkynes > Alkenes > Alkanes. The strength of an acid is commonly expressed in units of pKa — the lower the pKa, the stronger the acid. Among the hydrocarbons, terminal alkynes have lower pKa values and are, therefore, more acidic. For example, the pKa values for ethane, ethene, and acetylene are 51, 44, and 25, respectively, as shown here.
Indicators
Polyprotic Acids