Related Experiment Video

Updated: May 19, 2026

Force System with Vertical V-Bends: A 3D In Vitro Assessment of Elastic and Rigid Rectangular Archwires
08:46

Force System with Vertical V-Bends: A 3D In Vitro Assessment of Elastic and Rigid Rectangular Archwires

Published on: July 24, 2018

A systematic review of force decay in orthodontic elastomeric power chains

Abdelali Halimi1, Hicham Benyahia, Anas Doukkali

  • 1University Mohammed V-Souissi (UM5S), Oral Biomechanics and Biotechnology Research Unit, Dentofacial Orthopedics Department, College of Dental Medicine, centre hospitalier Ibn-Sina, BP 6212, Rabat-Instituts, Madinat Al Irfane, Rabat, Morocco. halimiali111@yahoo.fr

International Orthodontics
|August 22, 2012
PubMed
Abstract

More Related Videos

Mimicking and Measuring Occlusal Erosive Tooth Wear with the "Rub&Roll" and Non-contact Profilometry08:47

Mimicking and Measuring Occlusal Erosive Tooth Wear with the "Rub&Roll" and Non-contact Profilometry

Published on: February 2, 2018

A Finite Element Approach for Locating the Center of Resistance of Maxillary Teeth10:50

A Finite Element Approach for Locating the Center of Resistance of Maxillary Teeth

Published on: April 8, 2020

Related Concept Videos

Circular Shafts - Elastoplastic Materials01:24

Circular Shafts - Elastoplastic Materials

The study of solid circular shafts under stress shows that within the elastic limit, stress increases directly to the distance from the shaft's center. This relationship holds until the shaft reaches a critical point of stress, beyond which it begins to yield, marking the transition from elastic to plastic deformation. At this crucial juncture, the maximum torque the shaft can endure without permanent deformation is determined, signifying the limit of its elastic behavior.
As torque on the...
Residual Stresses in Circular Shafts01:10

Residual Stresses in Circular Shafts

In materials that exhibit elastic and plastic behavior, known as elastoplastic materials, residual stresses can accumulate when these materials experience plastic deformation. This deformation arises from either high levels of shearing stress or significant strains. Residual stresses are internal stresses that persist within a material after removing the external force causing deformation. This phenomenon is demonstrated when observing the behavior of a shaft under torque; notably, the shaft's...
Factors Affecting Creep01:28

Factors Affecting Creep

In normal-weight aggregate concrete, the hardened cement paste is the primary contributor to creep, whereas the aggregates, being stiffer than the cement paste, are more resilient to stress-induced deformation. The stiffness of the aggregates is defined by their modulus of elasticity, and the more voluminous they are in the concrete, the less it will creep.
Further, the water/cement ratio is critical, as a lower ratio increases concrete strength, thus reducing creep. The strength of the...
Power Expended by a Constant Force00:57

Power Expended by a Constant Force

The relationship between work done and the time taken to do it can be explained using the concept of power. For example, several sprinters in a race may have the same velocity when they reach the finish line, therefore doing the same amount of work, but the winner does it in the least amount of time. Thus, power is defined as the rate of doing work. Since work can vary as a function of time, the average power is defined as the work done during a time interval, divided by the time interval.