Effects of two in-office bleaching agents with different pH on the structure of human enamel: an in situ and in vitro study

This study evaluated the effects of two in-office bleaching agents (Beyond and Opalescence Boost) with different pH on the structure and mechanical properties of human enamel in vitro and in situ. One hundred and eight enamel slabs were obtained from freshly extracted premolars. The specimens were randomly distributed into nine groups (n=12), and the human saliva (HS) in the volunteers' oral cavities was used to simulate the in situ condition: Beyond + HS, Opalescence Boost (O-Boost) + HS, Control + HS, Beyond + artificial saliva (AS), O-Boost + AS, Control + AS, Beyond + distilled water (DW), O-Boost + DW, and Control + DW. The bleaching treatments were performed on the first and eighth day, and the total bleaching time was 90 minutes. Baseline and final surface roughness (RMS), surface morphology, microhardness, and fracture toughness (FT) were measured before the treatment and on the fifteenth day, respectively. Compared with control groups, surface alterations on enamel were found in the Beyond + AS and Beyond + DW groups under atomic force microscopy evaluation. Two-way analysis of variance and Tukey test revealed that the RMS showed significant intergroup differences for both storage condition and bleaching agent, whereas microhardness and FT revealed no significant alteration. The results indicated that in-office bleaching agents with low pH values could induce enamel morphology alterations under in vitro conditions. The presence of natural HS could eliminate the demineralization effect caused by low pH.