Related Experiment Video
Updated: May 19, 2026

Clean Sampling and Analysis of River and Estuarine Waters for Trace Metal Studies
Published on: July 1, 2016
Determination of copper speciation in highway stormwater runoff using competitive ligand exchange - Adsorptive
Jeffrey A Nason1, Matthew S Sprick1, Don J Bloomquist1
1School of Chemical, Biological, and Environmental Engineering, Oregon State University, 103 Gleeson Hall, Corvallis, OR 97331-2702, USA.
Abstract:
Low concentrations of dissolved copper have been shown to adversely affect the olfactory system of salmonid species, impairing their ability to avoid predators and likely increasing mortality. These studies have resulted in increased regulatory scrutiny of stormwater discharges to surface waters inhabited by threatened and endangered salmonid species. Because it is primarily the free ionic (Cu(2+)) and weakly complexed forms of copper that are bioavailable, it is critical to understand the speciation of copper in stormwater. This paper reports on the characterization of copper binding ligands and copper speciation in composite samples of highway stormwater runoff collected at four sites in Oregon, USA using competitive ligand exchange - adsorptive cathodic stripping voltammetry (CLE-ACSV). Although the concentration and strength of copper binding ligands in stormwater varied considerable between sites and storms, the vast majority (>99.9%) of the total dissolved copper in composite samples was complexed by organic ligands in stormwater. Although total dissolved copper concentrations range from 2 to 20 μg/L, the analytically determined free ionic copper concentrations did not exceed 10(-10) M (6.3 ng/L) in any of the fully characterized samples, suggesting that much of the copper in highway stormwater is not bioavailable. Analytically determined free ionic copper concentrations were compared with those predicted by a readily available chemical equilibrium models and found to be in reasonable agreement.
More Related Videos
10:31Detection and Recovery of Palladium, Gold and Cobalt Metals from the Urban Mine Using Novel Sensors/Adsorbents Designated with Nanoscale Wagon-wheel-shaped Pores
Published on: December 6, 2015
07:00Accumulation and Analysis of Cuprous Ions in a Copper Sulfate Plating Solution
Published on: March 20, 2019
Related Concept Videos
Voltammetry: Stripping Methods
Anodic Stripping Voltammetry (ASV)
ASV is used to determine metals and metalloids at trace levels. It involves two steps: deposition and stripping. First, a negative potential is applied to the...
Electrodeposition
Electrodeposition can...
Extraction: Advanced Methods
Precipitation and Co-precipitation
Precipitation Titration: Endpoint Detection Methods
In the Volhard method, a standard excess of AgNO3 is first added to the...
Ion-Exchange Chromatography