Expression of concern. Stress associated with group living in a long-lived bird

When a force is applied on a body, it undergoes deformation. In order to restore the body to its original shape and/or size, an opposite or restoring force is generated within the body. This restoring force is equal to the magnitude of the applied force, but acts in the opposite direction. The amount of this restoring force developed per unit area of the body is called stress. Stress is a tensor quantity and has the SI unit pascal. Stress can be separated into four broad categories depending...

Conservation of declining population focuses on ways of detecting, diagnosing, and halting a population decline. The approach uses methods to prevent populations from going extinct.

The stress response system, also known as the fight-or-flight response, is the body's automatic physiological reaction to perceived threats. Hans Selye introduced the concept of General Adaptation Syndrome (GAS) to describe the predictable pattern of changes that occur in response to stress. GAS consists of three sequential stages: alarm, resistance, and exhaustion. This model helps explain how chronic stress can contribute to health problems.
Alarm stage
In the alarm stage, the body's initial...

Mate choice—the decision about whom to mate with—is a type of natural selection, since animals must reproduce to pass down their genes. Mate choice is also called intersexual selection because the behavior occurs between the sexes.

Stress concentration is when stress intensifies near discontinuities such as holes or abrupt cross-sectional changes in a structural member. This localized stress can often surpass the average stress within the member. The stress distribution in flat bars, either with a circular hole or varying widths connected by fillets, can be determined experimentally using a photoelastic method. The results are based on ratios of geometric parameters like the ratio of the hole's radius to the smaller width...

The concept of stress concentration is crucial for understanding how materials respond under bending stresses, particularly when there are irregularities or discontinuities in the material's geometry. Normally, stress in a symmetric member subjected to pure bending is assumed to be uniformly distributed across the entire cross-section. However, this assumption does not hold when there are variations in the cross-sectional geometry or the presence of notches and holes.
The stress concentration...