Rate-distortion analysis of dead-zone plus uniform threshold scalar quantization and its application--part I:

Jun Sun1, Yizhou Duan, Jiangtao Li

  • 1Institute of Computer Science and Technology, Peking University, Beijing 100871, China. jsun@pku.edu.cn

Related Concept Videos

Properties of the z-Transform I01:17

Properties of the z-Transform I

The z-transform is a fundamental tool in digital signal processing, enabling the analysis of discrete-time systems through its various properties. It is an invaluable tool for analyzing discrete-time systems, offering a range of properties that simplify complex signal manipulations. One fundamental property is linearity. For any two discrete-time signals, the z-transform of their linear combination equals the same linear combination of their individual z-transforms. This property is essential...
Second Order systems II01:18

Second Order systems II

In an underdamped second-order system, where the damping ratio ζ is between 0 and 1, a unit-step input results in a transfer function that, when transformed using the inverse Laplace method, reveals the output response. The output exhibits a damped sinusoidal oscillation, and the difference between the input and output is termed the error signal. This error signal also demonstrates damped oscillatory behavior. Eventually, as the system reaches a steady state, the error diminishes to zero.
If  ζ...
Properties of the z-Transform II01:16

Properties of the z-Transform II

The property of Accumulation in signal processing is derived by analyzing the accumulated sum of a discrete-time signal and using the time-shifting property to determine its z-transform. This principle reveals that the z-transform of the summed signal is related to the z-transform of the original signal by a multiplicative factor.
Moreover, the convolution property indicates that the convolution of two signals in the time domain corresponds to the product of their z-transforms in the frequency...
Routh-Hurwitz Criterion II01:19

Routh-Hurwitz Criterion II

In the application of the Routh-Hurwitz criterion, two specific scenarios can arise that complicate stability analysis.
The first scenario occurs when a singular zero appears in the first column of the Routh table. This situation creates a division by zero issues. To resolve this, a small positive or negative number, denoted as epsilon (∈), is substituted for the zero. The stability analysis proceeds by assuming a sign for ∈. If ∈ is positive, any sign change in the first column of the Routh...
Difference from Background: Limit of Detection01:05

Difference from Background: Limit of Detection

The limit of detection (LOD) is the smallest amount of analyte that can be distinguished from the background noise. The LOD value corresponds to the concentration at which the analyte signal is three times larger than the standard deviation of the blank signal. Below this value, the analyte signal cannot be differentiated from the background noise. It is calculated by dividing the calibration slope by 3 times the standard deviation of the blank signals.
The LOD indicates the presence or absence...