Related Experiment Video
Updated: May 18, 2026

08:22
A Novel Single Animal Motor Function Tracking System Using Simple, Readily Available Software
Published on: August 31, 2018
Concerns regarding use of one-tailed tests in the SLED-BD vs. CVVH trial
Critical Care (London, England)
|September 18, 2012
Abstract
No abstract available in PubMed .
More Related Videos
Related Concept Videos
Types of Hypothesis Testing
There are three types of hypothesis tests: right-tailed, left-tailed, and two-tailed.
When the null and alternative hypotheses are stated, it is observed that the null hypothesis is a neutral statement against which the alternative hypothesis is tested. The alternative hypothesis is a claim that instead has a certain direction. If the null hypothesis claims that p = 0.5, the alternative hypothesis would be an opposing statement to this and can be put either p > 0.5, p < 0.5, or p ≠ 0.5.
When the null and alternative hypotheses are stated, it is observed that the null hypothesis is a neutral statement against which the alternative hypothesis is tested. The alternative hypothesis is a claim that instead has a certain direction. If the null hypothesis claims that p = 0.5, the alternative hypothesis would be an opposing statement to this and can be put either p > 0.5, p < 0.5, or p ≠ 0.5.
Comparing Experimental Results: Student's t-Test
The t-test is a statistical method used to compare the sample mean with a population mean or compare two means from two data sets. The test statistic is calculated from the standard deviation, mean, and number of measurements in the data set at a selected confidence interval and then compared to a table of critical values at this confidence level. If the test statistic is smaller than the critical value, the null hypothesis is accepted. In this case, we state that the difference between the...
Wald-Wolfowitz Runs Test II
The Wald-Wolfowitz runs test, commonly referred to as the runs test, is a nonparametric test used to assess the randomness of ordered data. The test evaluates the number of runs, which are consecutive sequences of similar elements within the data. If the number of runs is significantly higher or lower than expected, the data is considered non-random, indicating a detectable pattern or structure.
For binary data, runs are identified using symbols such as + and −, or equivalently, 1s and 0s. In...
For binary data, runs are identified using symbols such as + and −, or equivalently, 1s and 0s. In...
McNemar's Test
McNemar's Test is a nonparametric statistical test used to determine if there is a significant difference in proportions between two related groups when the outcome is binary (e.g., yes/no, success/failure). It is beneficial when we have paired data, such as pre-test/post-test designs, where the same subjects are measured under two different conditions. The test is named after the statistician Quinn McNemar, who introduced it in 1947. It is commonly used in situations where subjects are...

