Influence of periodontal ligament simulation and splints on strains developing at the cervical area of a tooth crown

Many in vitro tooth models do not incorporate periodontal ligament (PDL) simulation. This study presents the influence of physiologically loaded occlusal splints on cervical strains in a model incorporating roots and PDL. Four sets (N = 10) of occlusal splints differing in material (hard/soft) and location (upper/lower) were prepared for first maxillary and mandibular anatomic molars. Two strain gauges were bonded to the buccal and lingual aspects of the lower molar. Teeth were embedded in acrylic resin with/without a PDL-simulating material. Force vs. strain data were acquired during loading and the maximal strains at 500 N were analyzed. When PDL was incorporated into the model without splints, buccal compressive strains were significantly decreased. Usage of a soft splint resulted in compressive strains on both tooth aspects. Usage of a hard splint on the lower tooth resulted in higher compressive strains on the lingual side compared with the buccal side, whereas usage of this splint on the upper tooth resulted in tensile strains on the lingual side. Bending towards the buccal side occurred when the splints were located on the upper tooth. Soft splints reduce buccal bending, but do not reduce cervical strains. Periodontal ligament stimulation materials should therefore be incorporated in models involving teeth.