Improved limit on direct α decay of the Hoyle state

O S Kirsebom1, M Alcorta, M J G Borge

  • 1Department of Physics and Astronomy, Aarhus University, DK-8000 Århus C, Denmark. oliskir@phys.au.dk

Physical Review Letters
|September 26, 2012
PubMed

Related Concept Videos

Nuclear Overhauser Enhancement (NOE)01:06

Nuclear Overhauser Enhancement (NOE)

Irradiation of a spin-active nucleus causes an increase or decrease in the signal intensity of neighboring nuclei that are not necessarily chemically bonded or involved in J-coupling. This phenomenon, called the nuclear Overhauser enhancement (NOE), results from through-space interactions between the nuclear spins. The NOE effect decreases with increasing internuclear distance and is generally not observed beyond 4 angstroms. In NOE, dipole-dipole interactions between neighboring spin-active...
¹³C NMR: ¹H–¹³C Decoupling01:04

¹³C NMR: ¹H–¹³C Decoupling

The probability of having two carbon-13 atoms next to each other is negligible because of the low natural abundance of carbon-13. Consequently, peak splitting due to carbon-carbon spin-spin coupling is not observed in spectra. However, protons up to three sigma bonds away split the carbon signal according to the n+1 rule, resulting in complicated spectra.
A broadband decoupling technique is used to simplify these complex, sometimes overlapping, signals. Broadband decoupling relies on a...
Double Resonance Techniques: Overview01:12

Double Resonance Techniques: Overview

Double resonance techniques in Nuclear Magnetic Resonance (NMR) spectroscopy involve the simultaneous application of two different frequencies or radiofrequency pulses to manipulate and observe two distinct nuclear spins. One important application of double resonance is spin decoupling, which selectively suppresses coupling with one type of nucleus while observing the NMR signal from another nucleus, simplifying the spectrum and enhancing resolution.
Spin decoupling is usually achieved by...
Hess's Law03:40

Hess's Law

There are two ways to determine the amount of heat involved in a chemical change: measure it experimentally, or calculate it from other experimentally determined enthalpy changes. Some reactions are difficult, if not impossible, to investigate and make accurate measurements for experimentally. And even when a reaction is not hard to perform or measure, it is convenient to be able to determine the heat involved in a reaction without having to perform an experiment.
Evaluating Limits by Direct Substitution01:29

Evaluating Limits by Direct Substitution

In the analysis of functions that represent continuous physical phenomena, it is often necessary to determine the output value as the input approaches a specific point. When a combination of algebraic terms defines the function and exhibits no discontinuities or abrupt changes near the point of interest, the limit of the function can be evaluated directly. This process, known as direct substitution, involves replacing the variable in the expression with the value it approaches.Direct...
Limits of the First Law of Thermodynamics01:22

Limits of the First Law of Thermodynamics

Spontaneous processes, like a rock falling to the ground or sodium reacting with chlorine, occur without external work and often involve a decrease in the system‘s energy. However, certain endothermic processes, such as the dissolution of sodium chloride in water, occur spontaneously even though they increase the energy of the system. This limitation suggests that the First Law of Thermodynamics, which states that the total energy of a system is constant in an isolated system, cannot fully...