Related Experiment Video
Updated: May 18, 2026
Contact Hypersensitivity as a Murine Model of Allergic Contact Dermatitis
Published on: September 26, 2022
Patch testing with 2.0% (0.60 mg/cm 2) formaldehyde instead of 1.0% (0.30 mg/cm 2) detects significantly more contact
Ann Pontén1, Kristiina Aalto-Korte, Tove Agner
1Department of Occupational and Environmental Dermatology, Skåne University Hospital, Lund University, 205 02 Malmö, Sweden. ann.ponten@med.lu.se
Background:
The currently used patch test concentration for formaldehyde is 1.0% (wt/vol) in water. However, clinical experience and previous studies suggest that 1.0% might be insufficient for detecting an optimized number of clinically relevant cases of contact allergy to formaldehyde.
Objectives:
To validate earlier patch test results for comparison of 1% (wt/vol) and 2% (wt/vol) formaldehyde in water, and to investigate co-reactivity with quaternium-15.
Materials And Methods:
In 12 dermatology clinics, 3591 patients were routinely patch tested simultaneously with 2.0% (wt/vol) (0.60 mg/cm(2)) and 1.0% (wt/vol) (0.30 mg/cm(2)) formaldehyde. Micropipettes were used for delivering the exact dosage of the allergen.
Results:
Significantly more patients reacted to 2.0% formaldehyde than to 1.0% (3.4% versus 1.8%, p < 0.001). Overall, there were no sex differences between those reacting positively to 2.0% and 1.0%. Of 25 quaternium-15-positive patients, 4 (0.1%) reacted positively without reacting to formaldehyde.
Conclusion:
On the basis of the results of this multicentre study, as well as of previous studies, it can be suggested that 2.0% (wt/vol) in water formaldehyde should be used in routine patch testing in the baseline series.
