Related Experiment Video
Updated: May 18, 2026

A Practical Guide on Coupling a Scanning Mobility Sizer and Inductively Coupled Plasma Mass Spectrometer (SMPS-ICPMS)
Published on: July 11, 2017
Comparison of two lab-made spray chambers based on MSIS™ for simultaneous metal determination using vapor
A Fuentes-Cid1, J Villanueva-Alonso, E Peña-Vázquez
1Department of Analytical Chemistry, Nutrition and Bromatology, Faculty of Chemistry, University of Santiago de Compostela, Avenida de las Ciencias s/n, E-15782, Santiago de Compostela, Spain.
Abstract:
The objective of this study is to evaluate the performance of two lab-made systems based on the Multimode Introduction System (MSIS™) and the modified MSIS™, to generate and introduce vapors of Ag, Cu, Cd, Cu, Ni, Sn, Zn, and also Au in the ICP torch. An univariate procedure was used to select the optimized working conditions (Ar flow, sample, reductant and waste flows, and reagent concentrations). Optimum conditions for working with modified MSIS were: nitric acid concentration 0.35 M, 8-hydroxyquinoline concentration: 40 mg L(-1), sodium borohydride concentration: 1.75% (w/v)+0.4% (w/v) NaOH, argon purge flow to sweep the vapors to the torch: 1.2 L min(-1), sample flow and sodium borohydride flows: 2.3 L min(-1); waste flow: 7.7 mL min(-1). For the optimum working conditions for lab-made MSIS in dual mode the concentration of 8-hydroxyquinoline was 225 mg L(-1), the Ar purge flow was 0.75 L min(-1), and the conventional nebulization flow was 2.3 L min(-1). The sensitivity obtained was higher using the lab-made MSIS than using the lab-made modified MSIS or a forced outlet gas-liquid separator. The limits of detection were better for Au, Cd, Sn than those obtained using conventional nebulization; the measurements were precise (RSDs≤5% in dual mode) and a good accuracy was obtained in the determination of Cd, Cu, Ni and Zn in a wastewater reference material using aqueous calibration and the lab-made MSIS in dual mode.
Related Concept Videos
Inductively Coupled Plasma–Mass Spectrometry (ICP–MS): Overview
Inductively Coupled Plasma Atomic Emission Spectroscopy: Principle
The ions and electrons produced interact with the fluctuating magnetic field created by a water-cooled...
Atomic Emission Spectroscopy: Lab
Inductively Coupled Plasma Atomic Emission Spectroscopy: Instrumentation
There are three main types of inductively coupled plasma atomic emission spectroscopy (ICP-AES) instruments: sequential, simultaneous multichannel, and Fourier transform instruments, with the latter being less commonly used.
Atomic Emission Spectroscopy: Instrumentation
Inductively Coupled Plasma-Mass Spectrometry (ICP-MS): Interferences
