Anisotropy of bovine cortical bone tissue damage properties

Bone is a heterogeneous, anisotropic natural composite material. Several studies have measured human cortical bone elastic properties in different anatomical directions and found that the Young's modulus was highest in the longitudinal, followed by the tangential and then by the radial direction. This study compared the Young's modulus, the accumulated microdamage and local strains related to the failure process in these three anatomical directions. Cortical bone samples (≈360 μm×360 μm) were mechanically tested in three-point bending and concomitantly imaged to assess local strains using digital image correlation technique. The bone whitening effect was used to detect microdamage formation and propagation. No statistically significant difference was found between the Young's modulus of longitudinal (9.4±2.0 GPa) and tangential (9.9±1.8 GPa) bovine bone samples, as opposed to previous findings on human bone samples. The same similarity was found for the whitening values (5000±1900 pix/mm(2) for longitudinal, 5800±2600 pix/mm(2) for tangential) and failure strains (16.8±7.0% for longitudinal, 19.1±3.2% for tangential) as well. However, significantly lower values were observed in the radial samples for Young's modulus (5.92±0.77 GPa), whitening (none or minimal) and failure strain (10.8±3.8%). For strains at whitening onset, no statistically significant difference was seen for the longitudinal (5.1±1.6%) and radial groups (4.2±2.0%), however, the tangential values were significantly greater (7.0±2.4%). The data implies that bovine cortical bone tissue in long bones is designed to withstand higher loads in the longitudinal and tangential directions than in the radial one. A possible explanation of the anisotropy in the mechanical parameters derived here might be the structure of the tissues in the three directions tested.