Related Experiment Video
Updated: May 17, 2026
Sampling, Sorting, and Characterizing Microplastics in Aquatic Environments with High Suspended Sediment Loads and Large Floating Debris
Published on: July 28, 2018
Characteristics of road sediment fractionated particles captured from paved surfaces, surface run-off and detention
M Kayhanian1, E R McKenzie, J E Leatherbarrow
1Department of Civil and Environmental Engineering, One Shields Avenue, Ghausi Hall, University of California, Davis, CA 95616, United States. mdkayhanian@ucdavis.edu
Abstract:
This study presents the results of evaluating changes in properties of road sediment fractionated particles at the source (dry pavement), during transport (highway runoff) and after deposition (dry detention basin). A total of 38 solid particle samples were collected from paved surface, highway runoff, and from three locations within detention basins. Each sample was size-fractionated ranging from 38 μm to 1000 μm. Key results were that: (i) less than 2% of total particle mass in four vacuumed solid samples was associated with the <38 μm fraction compared to 47 to 82% in centrifuged highway runoff samples and 25% for detention basin sediments, (ii) based on number concentrations more than 90% of particles from all sources were smaller than 38 μm, (iii) the densities of fractionated particles were generally within the range from 1.5 to 2.2g/cm(3); (iv) all collected particles were predicted to resist aggregation in solution with a typical measure of surface potential, the zeta potential, typically ranging from -15 to -30 mV, (v) metal concentrations increased with decreasing particle size for vacuumed samples from the highway shoulder and parking lot, however, size dependent trends in metal concentrations were less apparent in centrifuged highway runoff samples and detention basin sediment samples; (vi) the distributions of metal mass across sieved size fractions generally followed patterns of particle mass distribution in which less than 10% of the total Cu, Pb, and Zn mass was associated with particles <38 μm; (vii) metal mass distributions tended toward increasing metal fractions in finer particle fractions along a gradient from the inlet to the outlet of the detention basins; and (viii) individual particle morphology (1 < d(p) < 10 μm) showed that particles were not smooth or spherical, clearly deviating from the assumptions typically used in estimating particle settling velocities using Stokes' Law.
More Related Videos
Related Concept Videos
01:16Precipitate Formation and Particle Size Control
The obtained precipitate should be either a pure substance of known composition or easily converted to one by a simple process, such as ignition or drying. In addition, the precipitate should be insoluble and easily filterable. In general, filterability...
01:18Sampling Methods: Sample Types
Solid samples include a variety of substances, such as sediments from water bodies, soil, metals, and biological tissues. Two standard methods for extracting sediments from water bodies are grab sampling and piston coring. Grab sampling involves using a device to collect a discrete sediment sample from the bottom of a water body with minimal disturbance. Grab samples do not always represent the entire area due to...
01:29Aggregates Classification
Petrographic classification groups aggregates based on common mineralogical characteristics. Some of the common mineral groups found in aggregates are...
01:25Shape and Texture of Coarse Aggregate
01:25Deleterious Substances in Aggregate
Another type of impurity is clay and fine material that...
01:24Design Example: Aggregate Gradation
The grading, or particle-size distribution, of sand is determined using sieve analysis, with standard sizes ranging from 150 μm to 10 mm (ASTM No. 100 sieve to 3⁄8 in. sieve). Sand is sampled...