Related Experiment Video
Updated: May 16, 2026

Determination of the Gas-phase Acidities of Oligopeptides
Published on: June 24, 2013
Gas-phase basicity of 2-furaldehyde
Andreina Ricci1, Simona Piccolella, Federico Pepi
1Department of Scienze della Vita, Second University of Naples, Caserta, Italy. andreina.ricci@unina2.it
Abstract:
2-Furaldehyde (2-FA), also known as furfural or 2-furancarboxaldehyde, is an heterocyclic aldehyde that can be obtained from the thermal dehydration of pentose monosaccharides. This molecule can be considered as an important sustainable intermediate for the preparation of a great variety of chemicals, pharmaceuticals and furan-based polymers. Despite the great importance of this molecule, its gas-phase basicity (GB) has never been measured. In this work, the GB of 2-FA was determined by the extended Cooks's kinetic method from electrospray ionization triple quadrupole tandem mass spectrometric experiments along with theoretical calculations. As expected, computational results identify the aldehydic oxygen atom of 2-FA as the preferred protonation site. The geometries of O-O-cis and O-O-trans 2-FA and of their six different protomers were calculated at the B3LYP/aug-TZV(d,p) level of theory; proton affinity (PA) values were also calculated at the G3(MP2, CCSD(T)) level of theory. The experimental PA was estimated to be 847.9 ± 3.8 kJ mol(-1), the protonation entropy 115.1 ± 5.03 J mol(-1) K(-1) and the GB 813.6 ± 4.08 kJ mol(-1) at 298 K. From the PA value, a ΔH°(f) of 533.0 ± 12.4 kJ mol(-1) for protonated 2-FA was derived.
Related Concept Videos
Basicity of Aliphatic Amines
To measure the basicity of amines, two conventions are generally used. The first defines Kb as the basicity constant for the deprotonation reaction of water by the amine, as presented in Figure 1. Conventionally, lower Kb indicates higher...
Acidity and Basicity of Alcohols and Phenols
Basicity of Heterocyclic Aromatic Amines
Basicity of Aromatic Amines
Acidity and Basicity of Carboxylic Acid Derivatives
The relative acidic strength of the derivatives can be explained based on the extent of resonance stabilization of the conjugate base. The...
Acidity of 1-Alkynes
The acidic strength of hydrocarbons follows the order: Alkynes > Alkenes > Alkanes. The strength of an acid is commonly expressed in units of pKa — the lower the pKa, the stronger the acid. Among the hydrocarbons, terminal alkynes have lower pKa values and are, therefore, more acidic. For example, the pKa values for ethane, ethene, and acetylene are 51, 44, and 25, respectively, as shown here.

