Related Experiment Video
Updated: May 16, 2026

Protocol of Electrochemical Test and Characterization of Aprotic Li-O2 Battery
Published on: July 12, 2016
The carbon electrode in nonaqueous Li-O2 cells
Muhammed M Ottakam Thotiyl1, Stefan A Freunberger, Zhangquan Peng
1School of Chemistry, University of St. Andrews, North Haugh, St. Andrews, Fife KY16 9ST, United Kingdom.
Abstract:
Carbon has been used widely as the basis of porous cathodes for nonaqueous Li-O(2) cells. However, the stability of carbon and the effect of carbon on electrolyte decomposition in such cells are complex and depend on the hydrophobicity/hydrophilicity of the carbon surface. Analyzing carbon cathodes, cycled in Li-O(2) cells between 2 and 4 V, using acid treatment and Fenton's reagent, and combined with differential electrochemical mass spectrometry and FTIR, demonstrates the following: Carbon is relatively stable below 3.5 V (vs Li/Li(+)) on discharge or charge, especially so for hydrophobic carbon, but is unstable on charging above 3.5 V (in the presence of Li(2)O(2)), oxidatively decomposing to form Li(2)CO(3). Direct chemical reaction with Li(2)O(2) accounts for only a small proportion of the total carbon decomposition on cycling. Carbon promotes electrolyte decomposition during discharge and charge in a Li-O(2) cell, giving rise to Li(2)CO(3) and Li carboxylates (DMSO and tetraglyme electrolytes). The Li(2)CO(3) and Li carboxylates present at the end of discharge and those that form on charge result in polarization on the subsequent charge. Li(2)CO(3) (derived from carbon and from the electrolyte) as well as the Li carboxylates (derived from the electrolyte) decompose and form on charging. Oxidation of Li(2)CO(3) on charging to ∼4 V is incomplete; Li(2)CO(3) accumulates on cycling resulting in electrode passivation and capacity fading. Hydrophilic carbon is less stable and more catalytically active toward electrolyte decomposition than carbon with a hydrophobic surface. If the Li-O(2) cell could be charged at or below 3.5 V, then carbon may be relatively stable, however, its ability to promote electrolyte decomposition, presenting problems for its use in a practical Li-O(2) battery. The results emphasize that stable cycling of Li(2)O(2) at the cathode in a Li-O(2) cell depends on the synergy between electrolyte and electrode; the stability of the electrode and the electrolyte cannot be considered in isolation.
Related Concept Videos
Batteries and Fuel Cells
Voltaic/Galvanic Cells
Spontaneous redox reactions occur abundantly in nature. The chemical reaction occurring in a disposable AA battery powering our remote controls is one such example of a spontaneous redox reaction. Another example is the immersion of coiled copper wire into an aqueous silver nitrate solution. The reaction shows a gradual, visually impressive color change from colorless to bright blue and the formation of a grey precipitate on the copper wire. In this experiment,...
Electrochemical Cells
Types of Reversible Electrodes
Electrodes: Overview
There are two main types of electrodes in electrochemical cells. The first type, known as the working or indicator electrode, has a potential that is sensitive to the analyte's concentration and reacts to changes in the...
Electrodeposition
Electrodeposition can...

