Interval estimation of the mean difference in the analysis of over-dispersed count data

Krishna K Saha1

  • 1Department of Mathematical Sciences, Central Connecticut State University, New Britain, CT 06050, USA. sahakrk@ccsu.edu

Related Concept Videos

Behrens–Fisher Test00:57

Behrens–Fisher Test

The Behrens-Fisher test is a statistical method designed to address the Behrens-Fisher problem, which arises when comparing the means of two normally distributed populations with unequal variances. Unlike the Student's t-test, which assumes equal variances, the Behrens-Fisher test allows for mean comparison without this restrictive assumption. This flexibility makes it particularly valuable in scenarios where two independent samples exhibit normality but lack variance homogeneity.
This test is...
Statistical Analysis: Overview01:11

Statistical Analysis: Overview

When we take repeated measurements on the same or replicated samples, we will observe inconsistencies in the magnitude. These inconsistencies are called errors. To categorize and characterize these results and their errors, the researcher can use statistical analysis to determine the quality of the measurements and/or suitability of the methods.
One of the most commonly used statistical quantifiers is the mean, which is the ratio between the sum of the numerical values of all results and the...
Midrange01:07

Midrange

A somewhat easy to compute quantitative estimate of a data set’s central tendency is its midrange, which is defined as the mean of the minimum and maximum values of an ordered data set.
Simply put, the midrange is half of the data set’s range. Similar to the mean, the midrange is sensitive to the extreme values and hence the prospective outliers. However, unlike the mean, the midrange is not sensitive to all the values of the data set that lie in the middle. Thus, it is prone to outliers and...
Estimating Population Mean with Unknown Standard Deviation01:22

Estimating Population Mean with Unknown Standard Deviation

In practice, we rarely know the population standard deviation. In the past, when the sample size was large, this did not present a problem to statisticians. They used the sample standard deviation s as an estimate for σ and proceeded as before to calculate a confidence interval with close enough results. However, statisticians ran into problems when the sample size was small. A small sample size caused inaccuracies in the confidence interval.
William S. Gosset (1876–1937) of the Guinness...
Estimating Population Mean with Known Standard Deviation01:16

Estimating Population Mean with Known Standard Deviation

To construct a confidence interval for a single unknown population mean μ, where the population standard deviation is known, we need sample mean as an estimate for μ and we need the margin of error. Here, the margin of error (EBM) is called the error bound for a population mean (abbreviated EBM). The sample mean is the point estimate of the unknown population mean μ.
The confidence interval estimate will have the form as follows:
(point estimate - error bound, point estimate + error bound)
The...
One-Way ANOVA: Equal Sample Sizes01:15

One-Way ANOVA: Equal Sample Sizes

One-Way ANOVA can be performed on three or more samples with equal or unequal sample sizes. When one-way ANOVA is performed on two datasets with samples of equal sizes, it can be easily observed that the computed F statistic is highly sensitive to the sample mean.
Different sample means can result in different values for the variance estimate: variance between samples. This is because the variance between samples is calculated as the product of the sample size and the variance between the...