Related Experiment Video
Updated: May 16, 2026
Quasistatic Mechanical Testing for Computer-Aided Design and Manufacturing Occlusal Veneers Cemented to Milled Dentin Analog Material
Published on: December 20, 2024
Three-dimensional fit of lithium disilicate partial crowns in vitro
Oliver Schaefer1, Harald Kuepper, Bernd W Sigusch
1Policlinic of Prosthetic Dentistry and Material Science, Centre for Dental Medicine, Jena University Hospital, An der Alten Post 4, 07743 Jena, Germany. oliver.schaefer@med.uni-jena.de
Objectives:
A novel three-dimensional scanning technique was used to investigate the effects a one-step and a two-step impression methods can have on the three-dimensional fit of ceramic partial crowns.
Methods:
An acrylic model of a mandibular first molar was prepared to receive a partial coverage all-ceramic crown (mesio-occlusal-distal inlay preparation with reduction of all cusps and rounded shoulder finish line of buccal wall). Type IV plaster replicates were cast based on one-step single viscosity (OS/SV), one-step dual viscosity (OS/DV), and two-step dual viscosity (TS/DV) impressions. Five partial crowns were fabricated per impression method using hot-pressed lithium disilicate ceramics. Then, preparation and restorations were digitized using a non-contact, white-light scanner featuring self-calibrating optics (overall measurement uncertainty of <5μm). Data were entered into quality inspection software which superimposed the records (best-fit-algorithm), calculated fit-discrepancies for every pixel, and colour-coded the results to aid visualization. Furthermore, mean quadratic deviations (RMS) were computed and analyzed statistically with a 1-way ANOVA. Scheffé's procedure was applied for multiple comparisons (α=0.05).
Results:
Mean RMS-values for marginal (internal) surfaces were: OS/SV 70 (20)μm, OS/DV 78 (34)μm, and TS/DV 107 (52)μm. Differences among impression techniques were statistically significant at p=0.006 (0.001). Qualitatively, occlusal ridges and preparation finish lines were over contoured, whereas inner occlusal boxes and the proximal-occlusal isthmus were under contoured.
Conclusions:
OS/SV and OS/DV impressions resulted in statistically significantly smaller marginal and internal discrepancies than the two-step technique.
Clinical Significance:
Marginal and internal fit of hot-pressed lithium disilicate partial crowns depended on the employed impression technique. One-step impressions are preferred over two-step techniques in many day-to-day clinical situations, especially for the fabrication of partial coverage crown restorations.
