Related Experiment Video
Updated: May 16, 2026

A Filter-based Surface Enhanced Raman Spectroscopic Assay for Rapid Detection of Chemical Contaminants
Published on: February 19, 2016
[Detection and analysis of polycyclic aromatic hydrocarbons using surface-enhanced Raman spectroscopy]
Jun Ma1, Shu Liu, Xiao-Feng Shi
1Optics & Optoelectronics Laboratory, Ocean University of China, Qingdao 266100, China. majun@ouc.edu.cn
Abstract:
In the present paper, the gold colloid with parameters optimized was used as surface-enhanced Raman scattering (SERS) active substrate to realize the trace detection of polycyclic aromatic hydrocarbons (PAHs) in water for the first time. Gold colloids with different size were prepared using chemical reduction method, and the optimum size selected at 632.8 nm excitation wavelength by experiment is (32 +/- 3) nm. The influence of pH value on the enhancement of PAHs was researched, and the optimal pH value is 13. Spectral intensity increased by approximately 20-fold compared with pH 6. The SERS spectra of naphthalene, phenanthrene and pyrene aqueous solutions were detected by the optimum gold colloid, and the minimum concentrations obtained were 20, 4 and 4 nmol x L(-1), respectively. There was a linear relationship between peak intensity and concentration, and the linear regression correlation coefficients were all above 0.985. For the mixture, the authors could distinguish each PAH easily for their own characteristic peaks. The experimental results show that such active substrate has a very high sensitivity as well as good application prospect.
Related Concept Videos
Raman Spectroscopy: Overview
However, a small fraction of the scattered light exhibits a frequency shift due to the exchange of energy between the incident photons and the...
Raman Spectroscopy Instrumentation: Overview
The monochromatic laser source, typically using visible or near-infrared radiation, generates a highly focused beam of light. This light interacts with the molecules of the sample, scattering some of the light. Liquid and gaseous samples are usually tested in ordinary glass capillaries, while solids can be analyzed as powders packed in capillaries or as potassium...

