Related Experiment Video
Updated: May 15, 2026
Quasistatic Mechanical Testing for Computer-Aided Design and Manufacturing Occlusal Veneers Cemented to Milled Dentin Analog Material
Published on: December 20, 2024
In vitro evaluation of microleakage under ceramic and metal brackets bonded with LED and plasma arc curing
Abdolrahim Davari1, Soghra Yassaei, Mariam Karandish
1Department of Operative Dentistry, School of Dentistry, Shahid Sadoughi University of Medical Sciences, Yazd, Iran.
Aim:
The aim of the present study was to evaluate these two high intensity light curing units regarding microleakage beneath metal and ceramic brackets.
Materials And Methods:
A total of 60 freshly extracted human premolar teeth were randomly divided into four groups of 15 samples; group I: Metal bracket + LED cured, group II: Ceramic bracket + LED cured, group III: Metal bracket + plasma arc cured, group IV: Ceramic bracket + plasma arc cured. After photopolymerization, the teeth were immersed in water and thermocycled (500 cycles between 5 and 55). Specimens were further sealed with nail varnish and stained with 5% basic fuchsin for 24 hours. All of the teeth were sectioned with two parallel longitudinal occlusogingival cuts and examined under a stereomicroscope. The microleakage was measured with a digital caliper and scored from 0 to 3 for marginal microleakage at the bracket-adhesive and adhesive-enamel interfaces from both the occlusal and gingival margins.
Results:
Microleakage was detected in all groups. The plasma arc cured group showed less microleakage than light emitting diode (LED) cured in all samples at the enamel-adhesive interface at the gingival margin (ceramic brackets, p = 0.009 and metal brackets, p = 0.005). The plasma arc cured samples showed less microleakage than LED cured in metal brackets at the adhesive-brackets interface at the occlusal margin (p = 0.033). While curing with an LED unit, ceramic brackets displayed significantly less microleakage than metal ones at the gingival margin of adhesive-enamel interface (p = 0.013). The gingival margin in all groups exhibited higher microleakage compared with those observed in occlusal sides in all sample groups (p < 0.001).
Conclusion:
1. LED units cause more microleakage than plasma arc units. 2. In all groups the microleakage at the gingival margin is greater than the occlusal margin.
Clinical Significance:
The microleakage formation permits the passage of bacteria and oral fluids initiating white spot lesions beneath the bracket base.
