Water soluble polymer films for intravascular drug delivery of antithrombotic biomolecules

Over the past 10 years, the number of percutaneous coronary intervention (PCI) procedures performed in the United States has increased by 33%; however, restenosis, which inhibits complete functional recovery of the vessel wall, remains a complication of this procedure. To traverse the complications associated with PCI, the investigation of therapeutic delivery has become an integral topic in modern research. One such therapeutic, a mimic of the proteoglycan decorin, termed DS-SILY, can mask exposed collagen and thereby effectively decrease platelet activation, has recently been developed by our lab. Drawing inspiration from coating technologies developed by the pharmaceutical industry, a fast-dissolving polymer film has been developed to deliver active therapeutic agents from a balloon catheter during PCI. This research investigates the release of DS-SILY from fast-dissolving polymer films composed of poly(vinyl alcohol) (PVA) and poly(ethylene glycol) (PEG). Thin, uniform polymer films were produced via spin coating technique. The dissolution speed of the polymer films was found to be dependent on the concentration of polymer solution, where at least 65% of the films were shown to dissolve into nanometer sized polymer fragments within 2 min. DS-SILY, up to 6.26 μg/cm(2), was loaded into the films and functional release of the mimic was demonstrated by its successful binding to collagen upon release. Furthermore, DS-SILY released from films resulted in increased platelet inhibition. These results indicate that use of fast-dissolving polymer films allow for the successful release of biomolecules and further investigation of their use for localized drug delivery during PCI procedures is warranted.