Related Experiment Video
Updated: May 15, 2026

Rapid Repetition Rate Fluctuation Measurement of Soliton Crystals in a Microresonator
Published on: December 15, 2021
Ultra-low timing-jitter 40GHz clock recovery using EAM-MZM double-loop and its application in a 640Gbit/s OTDM system
Deming Kong1, Hui Wang, Yan Li
1State Key Laboratory of Information Photonics and Optical Communications, Beijing University of Posts and Telecommunications, Beijing 100876, China. demingkong@bupt.edu.cn
Abstract:
An ultra-low timing-jitter clock recovery scheme based on EAM-MZM double-loop with the ability of simultaneous time-division demultiplexing is proposed and demonstrated in a 640 Gbit/s OTDM transmission system. Compared with traditional clock recovery scheme based on OEO loop, significant timing-jitter improvement of the 40 GHz recovered clock is realized: from 58 fs to 30 fs in back-to-back configuration and from 59 fs to 35 fs after 400 km transmission in the 100 Hz to 10 MHz range, without increasing the overall system complexity and cost. Enabled by the proposed clock recovery and demultiplexing scheme, error-free performance of the OTDM system is achieved after 400 km transmission with an average power penalty of 4dB.
Related Concept Videos
Time and frequency -Domain Interpretation of Phase-lag Control
Phase-lag controllers do not place a pole at zero, but instead influence the steady-state error by amplifying any finite,...
Clamper Circuit
Within this circuit, the diode's orientation prompts the capacitor to charge up to the level of the most negative peak of the input signal. Upon reaching this state, the diode ceases to conduct,...
Oscillations In An LC Circuit
Multimachine Stability
In analyzing the system, the nodal equations represent the relationship between bus voltages, machine voltages, and machine currents. The nodal equation is given by:
Linear time-invariant Systems
The input-output behavior of an LTI system can be fully defined by its response to an impulsive excitation at its input. Once this impulse response is known, the system's reaction to any other input can be calculated...
Upsampling