Thermodynamics of atomic and ionized hydrogen: analytical results versus equation-of-state tables and Monte Carlo

A Alastuey1, V Ballenegger

  • 1Laboratoire de Physique, ENS Lyon, UMR CNRS 5672, 46 allée d'Italie, 69364 Lyon Cedex 07, France.

Related Concept Videos

Hess's Law03:40

Hess's Law

There are two ways to determine the amount of heat involved in a chemical change: measure it experimentally, or calculate it from other experimentally determined enthalpy changes. Some reactions are difficult, if not impossible, to investigate and make accurate measurements for experimentally. And even when a reaction is not hard to perform or measure, it is convenient to be able to determine the heat involved in a reaction without having to perform an experiment.
Equation of State01:07

Equation of State

The equation of state is an equation that relates physical quantities, such as pressure, volume, temperature, and the number of moles, of a thermodynamics system with each other. The equation relating physical quantities with each other can be a simple mathematical expression or too complicated to express in mathematical form. In either case, a relationship between physical quantities exists. If the equation of state cannot be expressed in a mathematical form, then experimental data and...
Path Between Thermodynamics States01:21

Path Between Thermodynamics States

Consider the two thermodynamic processes involving an ideal gas that are represented by paths AC and ABC in Figure 1:
Atomic Spectroscopy: Effects of Temperature01:27

Atomic Spectroscopy: Effects of Temperature

Atomization, converting samples into gas-phase atoms and ions, is essential for atomic spectroscopy. The flame temperature required for atomization affects the efficiency of the atomic spectroscopic methods by increasing the atomization efficiency and the relative population of the excited and ground states.
At thermal equilibrium, the relative populations of excited and ground state atoms can be estimated using the Maxwell–Boltzmann distribution. For example, an increase in temperature from...
Thermochemical Equations02:55

Thermochemical Equations

For a chemical reaction (the system) carried out at constant pressure – with the only work done caused by expansion or contraction – the enthalpy of reaction (also called the heat of reaction, ΔHrxn) is equal to the heat exchanged with the surroundings (qp).
Variables and Equations of State01:27

Variables and Equations of State

The physical state of a pure substance can be defined by certain state variables such as volume (V), pressure (p), temperature (T), and amount of substance (n). When two gases are separated by a movable wall, the gas with the higher pressure naturally compresses the gas with the lower pressure. This causes the high-pressure gas to expand and the low-pressure gas to compress until both gases achieve mechanical equilibrium. At this point, their pressures equalize, and the movement of the wall...